JOYETECH ERoll

[unloaded]

Do you have a good suggestion for a needle tip bottle? I got one once and it was no good. Leaked around the cap.

10ml Plastic Needle Empty Dropper Bottle
These work really well but aren't the most pocket friendly, it does fine in shirt pocket though. I also have a sample bottle from RAWR that has the longer thinner Dripper tip. I has childproof cap and is pocket friendly, but its a little wider than the one posted above. It can cause an airlock when trying to fill if not careful. Also a lot of people are using the uCan, some have leaks some have no problems.

 

[peraspera]

I got cartridges, atties and atty covers from Good Prophets. My order shipped right away and everything has worked as it should.

 

[KrasH]

I got cartridges, atties and atty covers from Good Prophets. My order shipped right away and everything has worked as it should.

Same here, they are who I would recommend as well. Shipping was fast out the door.

 

[volume control]

I got some hangseng bottles from caterpillar vapes. The juice wasn't so good, desert ship is the least like an ash tray. But they have a small plastic tip that fits the carts, and are cheap even with fluid.

 

[KrasH]

I am still trying to find the site that has the tips you can buy. Will try to find it and post it tonight.

 

[-iD]

I also have a sample bottle from RAWR that has the longer thinner Dripper tip. I has childproof cap and is pocket friendly, but its a little wider than the one posted above. It can cause an airlock when trying to fill if not careful. Also a lot of people are using the uCan, some have leaks some have no problems.

RAWR = ?

tap'd on my Google Galaxy Nexus

 

[dirquist]

RAWR = ?

tap'd on my Google Galaxy Nexus

Just type RAWR Vapor into google. Not sure if we are ok to put links here.

 

[Junebug79]

OK. I've been searching the thread and haven't found an answer yet. This should be an easy one-

How do you clean the atomizers? Just over a day of use and there was a lot of resistance. It was fully charged, liquid in the tank. I switched to a new atomizer, and it's working "fine" (still flavor issues.) At this rate tho, no way can I afford to just get new ones. What's the best way to clean out atomizers? I don't want to use alcohol, even tho I know some swear it's safe.

 

[Junebug79]

I have an electric stove so i made sure it was seated in a spoon so not touching the bottom of the pot where the most heat was. Im not sure if the rubber is ok sitting on the bottom of the pot. I have also just poured boiling water into a cup with an atty and it works pretty well if it soaks until the water cools and you rinse it

Ah, ok. So this is good, it seems. Yes? (Trick to searching was use "atty" not atomizer duh!)

 

[volume control]

Ah, ok. So this is good, it seems. Yes? (Trick to searching was use "atty" not atomizer duh!)

Yep, just make sure it soaks long enough! Usually i boil for 5-10 minutes, then leave it in the hot water until its cool enough to reach in and grab it.

If you are having trouble getting air through the atty, sometimes if you take it out and use a syringe filled with hot (as hot as your tap gets) Then blast the hot water into the hole on the bottom of the atty so it goes through from bottom to top, you can clear the obstruction


Another common cause, which i do not think is your issue since another atty is fine, is the carts themselves. The air intake slits on the sides sometimes close up a bit, and can be opened back up using a razor/small flathead/tip of knife

 

[phonedude]

Received my E-roll yesterday. Really like it. I ordered an extra battery and two extra cones so I am all set with three working tiny ecigs.

Was impressed with the amount of vapor they put out.

I have used it (almost) exclusively since I received it and have had no issues. Occasionally I get nothing on puffing and then remember to move my fingers.

Thanks to this thread I knew exactly what I was getting and knew I would enjoy it.

 

[phonedude]

Forgot to mention I ordered some extra "tanks" as well. I had some old cartomizers I had ordered from Halo about a year ago. Hate the cartomizers but the plastic box they came in is great for the "tanks". So at least it wasn't a total loss.

 

[junkman]

I am starting to feel that if I could redesign this thing I would go with an even smaller battery, an increase the cartridge size. That and wider pcc to store a couple of the larger carts.

 

[KrasH]

Has anyone thought of turning two tanks into one.

 

[jingai]

Two tanks together I'm sure could be rigged but then you'd have to disassemble to charge, which makes it lose a lot of its charm for me.

Honestly I'd be fine with a smaller battery and larger tank as well. I think it'd even feel better balanced in the hand that way. I never vape the battery dry anyway since I use high nic juices.

Even for those that really don't want to go the high nic route, it's easier to swap the battery than it is to fill another tank. The atty fits tightly into the tank enough that generally you can pull the battery off without taking it with it.

 

[junkman]

I guess I need to buy about 10 more carts, and something to carry them in. Pre-fill them in the morning and then just swap them out as they go dry.

Could work pretty well.

I did get my high nic juice and that does seem like it will help with this device.

 

[Junebug79]

Yep, just make sure it soaks long enough! Usually i boil for 5-10 minutes, then leave it in the hot water until its cool enough to reach in and grab it.

If you are having trouble getting air through the atty, sometimes if you take it out and use a syringe filled with hot (as hot as your tap gets) Then blast the hot water into the hole on the bottom of the atty so it goes through from bottom to top, you can clear the obstruction


Another common cause, which i do not think is your issue since another atty is fine, is the carts themselves. The air intake slits on the sides sometimes close up a bit, and can be opened back up using a razor/small flathead/tip of knife

OK... on the tanks? where are or.... I've taken apart to the the basic components, the battery, the tank, the atomizer, the cone. I thought a new atty fixed it. Now i'm thinking my battery might be dead. I don't know! I'm not good at this stuff! I know how to work a lighter, that's about it! The first 3 or 4 hits are fine, then there's a lot of resistance, i put it back in the PCC. Next time i try - again, first 3 or 4 are fine, then resistance. This tank seems to be leaking a bit and has what look like condensation bubbles on it.

Did i wreck my battery? It doesn't seem to have liquid on it, but the top part of the atomizer was wet, and since it works for a wee bit right after it's charged... maybe it's not holding a charge? Or there's something else up? Ugh, at least my Mistic was simple.

 

[volume control]

Has anyone thought of turning two tanks into one.

I have one, the condensation comes right out into your mouth. Used quicksteel to bond

 

[volume control]

OK... on the tanks? where are or.... I've taken apart to the the basic components, the battery, the tank, the atomizer, the cone. I thought a new atty fixed it. Now i'm thinking my battery might be dead. I don't know! I'm not good at this stuff! I know how to work a lighter, that's about it! The first 3 or 4 hits are fine, then there's a lot of resistance, i put it back in the PCC. Next time i try - again, first 3 or 4 are fine, then resistance. This tank seems to be leaking a bit and has what look like condensation bubbles on it.

Did i wreck my battery? It doesn't seem to have liquid on it, but the top part of the atomizer was wet, and since it works for a wee bit right after it's charged... maybe it's not holding a charge? Or there's something else up? Ugh, at least my Mistic was simple.

Youre flooding your atty. I feel like your juice is too thin and this device likes thicker stuff, but other people on here say they have no problem with thin juice. It is wicking too much though. You can clear a flood by taking a few good hits in succession usually.

 

[four2109]

Two tanks together I'm sure could be rigged but then you'd have to disassemble to charge, which makes it lose a lot of its charm for me.

Even for those that really don't want to go the high nic route, it's easier to swap the battery than it is to fill another tank. The atty fits tightly into the tank enough that generally you can pull the battery off without taking it with it.

Until you do that and the silicone base separates from the bottom of the atomizer. That happened to me once when I forgot to take the tank off.

Junkman, I can refill faster than changing a tank. Keep it simple.