Just GG
- Thread starter imeothanasis
- Start date
- th_trl_thread_readers 0
- Status
I'm not worried about voltage drop Supa, I'm more concerned about how the center pin sits on the connector. Is the center pin's (not the brass extension) OD larger than the 2mm gap on the connector? I don't have anything to measure the center pin but it looks less than 3mm to me. Seems like if the two don't line up perfectly, the center pin could get push sideways and half slip into the channel.
I measured one of mine and found 2.9mm for just the shaft no brass[alloy] nut.
Its 3mm river, so the touching surface is 1mm. Its more than enough for the current. Just GG doesnt have any power loss, dont worry at all about this.
If Ody works with its GGTS base then Iatty works too aal. I made those bases equal. But even if you need an adjustment, justGG gives you this ability with its moving bolt inside the moving pole of CT.
I dont know about penelope base but I am sure it will work because of the above reason
I dont know about penelope base but I am sure it will work because of the above reason
yes aal. The only pieces that are not brass are the CT and the 510 connector.
Rings on button must stay SS to avoid them get dirty because if they get dirty they wouldnt get cleaned easily because they are knurled
Rings on button must stay SS to avoid them get dirty because if they get dirty they wouldnt get cleaned easily because they are knurled
I had made it in the past like this buddy but people didnt like it, me too. So button is exactly the same as GGTS's
very good question river. But battery always will push center post of CT in the right direction, so the center post will always come totally vertical.
imeo excuse did i miss a few posts, the color of new brass alloy is less yellow compared to the previous one, right? but i seem to remember who has best features, is there any picture of a justgg version in brass?
finally, i wanted to know if the connector, always brass, in preorder are the same that have been recently distributed by e-smoke guru,
thanks
finally, i wanted to know if the connector, always brass, in preorder are the same that have been recently distributed by e-smoke guru,
thanks
hi my good friend kin
I dont have a justGG is brass. And you are right about the new alloy, its less yellow that then usual brass
I didnt understand well about connector. But if you mean if it will be brass, then yes. All center pins are brass on justGG, and made from the new brass alloy
I dont have a justGG is brass. And you are right about the new alloy, its less yellow that then usual brass
I didnt understand well about connector. But if you mean if it will be brass, then yes. All center pins are brass on justGG, and made from the new brass alloy
Imeo, did you mean the button head (outside)? Or the fire pin in the inside? I think this is where some confusion lays.
the whole button is brass except the rings yankee (locking ring and adjustable ring). What you will see in brass when button is installed is only the head
Haha yes Yankee I had the same reaction. All SS will have a brass button head. It will be a down point for people who like exclusively all SS. But I can understand Imeo point of view. Best conductivity is priority.
To my opinion it looks much better like this aal. An all SS justGG with only a brass circle on its body
- Status
