I love my ipv4s so far, just got it a day ago though. Other than the foggy spot in the middle of the screen. Anyway. My question is. I'm running a sub tank mini on it with a 1.2 stock coil and it says 1.2 ohm on the front on memory 1 but when I check the resistance it says .5 then I exit out and it's in adjustment mode and is off by a watt. Then I go back to memory 1 and it's fine, hits the same as when I have it on my other mod does anyone have any ideas to why it does this.
just got my ipv4s
- Thread starter cte72
- Start date
- th_trl_thread_readers 0
- Status
stay out of memory mode if you plan to use a coil for a while... if you change coils alot then memory mode is ok... personally I dont care for memory mode... I just install the batteries, click 5 times, and see if things are close to what I made the coil to... and set the watts for that ohm value and vape till I smile 
- Status
Similar threads
- Locked
- Locked
