Just got my Wismec Rx200S and Avacado 24 and won't work ??

Status
Not open for further replies.

Petabread

Super Member
ECF Veteran
May 21, 2014
524
1,581
Miami, FL
What's up with this 200s? it doesn't seem to work with most of my tanks Avacado or limitless --- crappy 510 on the 200s ??? how do i fix??
You should never step on your mod and yell obscenities at it like, "hey, you smell like bathtub water after I poop in it!" Your mod might get offended and stop working.

You should also avoid lighting it on fire with a curling iron. If you do though, you should definitely suspend it on a clothing hanger and spray apple cider vinegar on it, because it cures cancer.

And never, I mean, never, take your mod apart and use it as a loin cloth to go sunbathing in. If you do, crabs will get inside your 510 connection and throw your mod's internal resistance off. If that happens, you can kiss accurate temperature control goodbye.
 
  • Like
Reactions: jjatl

TechnoGeek

Senior Member
ECF Veteran
Verified Member
Apr 6, 2016
75
58
60
USA
What's up with this 200s? it doesn't seem to work with most of my tanks Avacado or limitless --- crappy 510 on the 200s ??? how do i fix??


Don't tighten it down all the way.... If that works, then either buy some mod guards from kidney puncher, make some 510 washers/spacers, get a 510 heat sink, or your local lowes, homedepot has some washers that will probably work....The problem I had with the standard rx200 and the Gemini 22mm RTA was it would drop out of TC mode into wattage mode... If I left the atty loose it worked(no I wasn't forcing it down either...)... When that worked, I made a washers from cardboard, which worked... I then made one from plastic bottle cap, and finally ordered some 510 washers/spacers.....

upload_2016-6-27_16-49-5.png

upload_2016-6-27_16-50-7.png


Looking at : 510 Connectors Length

it seems that the 510 depth of the RX200s is ONLY 4.35mm AND the Limitless RDTA has a total 510 length of 4.64... So it is a BIT longer, but not much.....I wouldn't think enough, but.....
 
Status
Not open for further replies.

Users who are viewing this thread