K100-k101

[Nixit]

I received 4 K101's yesterday. I was hoping to use my evods on these but non of my evods fit. I've seen where many people use evods successfully with these. Did I get a bad batch? It has the ego threading but the well isn't deep enough for the screws on the evod to start.

 

[Kopfstimmen]

I haven't seen these, but I believe they are a slightly different connection. See if you can find some sort of adapter online. One website I saw states "Some clearomizers such as the Kanger T2 and T3 series are known not to fit and therefore will require a 510 eGo adapter..." Note that I have not tried the evod, either.
I know that I don't have much help in the way of experience, but I wanted to at least point you in a possibly useable direction, and maybe give you a bump. Good luck!

 

[Baditude]

Yes, the ego skirt on some ego-threaded clearomizers is too long for certain mod connectors that can accept ego threading. Getting an ego-to-ego or 510-to- ego adaptor should fix your problem.

 

[Nixit]

Thanks ya'll. I'll look into getting some adapters.

 

[Paksoy]

I received 4 K101's yesterday. I was hoping to use my evods on these but non of my evods fit. I've seen where many people use evods successfully with these. Did I get a bad batch? It has the ego threading but the well isn't deep enough for the screws on the evod to start.

Thanks ya'll. I'll look into getting some adapters.

After reading your post, I ran upstairs and tried it on all 3 of my K101's and they all screwed on and fired fine. I tested it with a PT2 mini, EVOD BCC, and CE4.... all with no problems. I didn't even know the K101's had an eGo thread ... bonus!!

I think you may have gotten a bad batch OR, I just got extremely lucky.