Kanger T3 Help!!

[GodAsMyth]

I have been vaping for less than a week now, I didn't like the cartos that came with it ego-C with 1000mAh upgrade batteries that I got (they liked to leak a lot) , so I bought Kanger T3's clearomizers. I love they way they look on my ego and they dont seem to leak so far, the only problem I have with them is they don't seem to have have a good throat hit and seem to produce a lot less vapor than the cartos did. Am I doing something wrong? Is there something I should know about these? I am using Joye 18mg pg menthol, the same that are in my cartos. I also have Joye 24mg pg menthol. Suggestions and tips with be appreciated.

 

[jangeisler]

If your batts arent adjustable in voltage, the t3's probably have too high resistance for your volts. Try buying a replacement coil with as low resistance as possible. I have a t3 on a vv device, and it rocks

The vape production depends on watts.

Watts can be increased by decreasing resistance in mizer, or increasing voltage.

 

[El_tecolote]

I prep all my Kangers by washing them out, drying, removing the little rubber top cap, and performing a short dry burn. Seems to help with TH and flavor. As has been said, perhaps your voltage is a little low. Also, I found it might take about a tankful of juice before they begin functioning well.