Kayfun lite+ clone wicking issue?

[egrets]

Hello,

I've been vaping for just about a month. Just got my first ever RDA today. EHPro Kayfun lite + clone. Got some coils prebuilt also. Reading at 1.4 ohm on my Provari.

I'm running a few problems I'm not sure what's the cause...

-cotton getting gunk up after just a few hours or broken from the middle: I'm thinking maybe the amount of cotton I use is not right. I'm still trying to experiment on that.

-I'm either getting too much juice or too airy of a draw. I'm running that in 3.5v right now. Tried opening the air hole, closed it tighter, etc...just keep getting either or. A draw would be tight enough for my preference, but then I'd have juice in my mouth; or it'd be gurgling like crazy, or it's too airy for me. I don't know what direction I should go about into fine tuning that. I've also tried a 50/50 juice, then a 100% vg, the outcome is about the same. I do like the flavor of the kayfun more though compare to the nautilus tank I was using before. I'm using the drip tip that comes with the EHPro clone.

--At times, I found the kayfun gets a little warm after a few vape, is that a concern?

Thanks a lot!

 

[time2quit]

To me it sounds like your problems are all related to wicking issues. Too much, or not enough cotton. In this video pay close attention to the amount of cotton used. I've had no issues since doing my builds exactly like the one in the video.
http://www.youtube.com/embed/PT2bkmsNVmI?feature=oembed

 

[time2quit]

BTW...if the KFL is getting warm, that is a issue with your coil. Make sure there are no shorts, or hot legs.

 

[215Z]

Where did you buy your EHPro KFL+ from?

 

[time2quit]

Where did you buy your EHPro KFL+ from?

Right here...the guy is a great seller also!
http://www.ebay.com/itm/281322290719

 

[egrets]

Ok...so I kinda solved my own problem finally. It turns out due to my limited muscle strength, I didn't screw in the part tightly enough. Then the center pin was not screwed on tight enough which probably is the cause of warmth on the RBA and coil/cotton getting burnt. I have to finally get a flat rubber band to make sure I screwed in everything properly. It's finally producing the flavor and the vapor to my liking and it's not getting warmth. Thank you for all the help on the forum.