Kayfun Lite dual coil setup

Status
Not open for further replies.

ballacaust

Full Member
Feb 12, 2014
10
1
Texas
I'm new here, so I apologize for not yet being able to post in the appropriate forum. Now, on to my question:
I have a kayfun lite rba that I've been using on an iTaste mvp 2.0. So far have been using a 1.6ohm microcoil setup with cotton and getting good results. I'm aware that the mvp is a regulated device, and that it technically will not go lower than 1 ohm on a coil. My question is, is it possible to build a dual-coil setup on the kayfun and be able to use it with the mvp? If so, what ohm rating should I be getting with each coil/with both attached together? If not, what would be a decently priced mech mod to able to achieve this?
 

ballacaust

Full Member
Feb 12, 2014
10
1
Texas
UPDATE: After watching a couple of videos about micro/nano coil builds for the KFL, I opted for just a single microcoil at 1.6 ohms. The coil I was using before actually wasn't a micro, just a regular 5-6 wraps a buddy made for me. Seems most of the reviews about a double barrel build for the KFL produced an insanely hot vape, something I'm not too fond of. Just finished my microcoil build with organic cotton, and it is vaping like a champ! Big clouds and huge flavor! Probably gonna stick with this on this particular RBA.
 
Status
Not open for further replies.

Users who are viewing this thread