I made a 1.2ohm Twisted 30 gauge chimney coil, wicked the cotton around the coil, Like I normally due with my builds, I did not put the chimney and top on. I then lightly packed the pulled apart and fluffed up pieces of cotton around the coil and base to fill in the spaces, then put a some juice on the cotton till it was wet and let sit and wetted it again and let it sit, but when I tried it produced good vapor but it just didn't wick or maybe to wet. Is there a certain way you lay the cotton in around the coil. Maybe it was the fact that the cotton was dry layered in then wetted, or are you supposed to presoak the cotton, Or am I missing something