Kayfun tips needed

[Joka]

So short and simple, my kayfun has too much flavor and not enough vapor production. Same 0.7 ohm micro coil and same green apple juice in a dripper and I'm fine. I can inhale until I have no room left and exhale. 4 second hit on my Kay and i choke more often and blow air out my nose lol

Is there anyway I can kill the flavor production? I must have used drippers as ADV for too long...but I love it but I want more from it, and i feel like it could be better.

 

[Caducity]

Sounds like your coil is too low.

Sent from my Nexus 7 using Tapatalk

 

[Steamer861]

All devices are different and a build that works in a dripper mite note work in a KF
with my KF's I find wicking is the issue I use a lot of wick and wrap it around the bottom step till its full of wicking material
If I use less wick I will get dry hits and burn my wick more often
The hight of the coil off the deck is also a factor I like mine almost touching the bottom air hole
If I lift it too much I get a harsh hit (too much throat hit) this is all subjective to the user so good advice is to keep trying different coil wick setups till you find what works for you The slightest little adjustment can make a big difference Hope you find what works for you
I did and love my KF's

 

[Joka]

I will try higher and lower for my coil placement. It's just hard to fiddle with a tank that you can't just pop apart, adjust, pop together, and test.

I kept unscrewing my air flow but it didn't really change anything but the pull, and I'm sure I was like 1 thread away from a mess lol so I quit.

Sent from my SCH-I545 using Tapatalk

 

[crxess]

Start by replacing the Drip tip with a Wide Bore.

Which model is it? If a Kayfun Lite Plus - Remove the Air Adjust screw all together

Also remember
Dripper vs tank
You Drink from a Glass
You sip through a straw

 

[Joka]

3.1, I have a trident v2 drip tip on it. It's pretty wide, it's not harsh that's bothering me the vape is smooth. I just don't see how such small plumes of vapor can make my lungs feel so weak

Sent from my SCH-I545 using Tapatalk

 

[vapdivrr]

usually more airflow, but if that's not a possibility then most likely you need more power. my kayfun doesn't produce as much vapor as my drippers, that's just the way it is. now I do have a set up that comes close and its with my dna-20 mod, I have it set up with one of my kayfuns along with a single twisted 27g micro coil and at 20 watts it blows pretty good.

 

[Joka]

I may just trade this thing for a good dripper i dont have lol

Sent from my SCH-I545 using Tapatalk

 

[vapdivrr]

I may just trade this thing for a good dripper i dont have lol

Sent from my SCH-I545 using Tapatalk

what set up are you running in the kayfun? resistance/ gauge/ diameter. and what device?

 

[Joka]

0.7 ohm 26g micro coil with cotton

Sent from my SCH-I545 using Tapatalk

 

[Jonathan Rizo]

Could use better batteries for more power output. My 26g micro coil (6-7 wrap) blows pretty good especially for a tank. Using sony vtc4 batteries. Becareful though you can melt the insulators


Sent from my iPhone using Tapatalk

 

[Steamer861]

all tanks have there limitations they will never perform like a dripper .7 seams low for a KF I run mine at 1.3 to 1.8
I have mine tuned in pretty good and they have excellent flavour not bad Vapour production but nothing like a dripper at .5
have you looked at the Reo's They work like a dripper and are convenient like a tank

 

[outxider]

I'm running a 28awg microcoil at 1.8ohm with organic cotton and flavor is awesome. Not expecting much vapor production but it puts out a bit. The kayfun is all about flavor. I ran a .6 coil microcoil once and ripped it out in a few days. Thats what the an RDA is for. Go with a higher ohm coil and appreciate the flavor. Leave the cloud production to the RDAs.

 

[Joka]

Thanks guys, guess I'll just increase my build experience. I could go pull my Reo G back off the shelf lol

Sent from my SCH-I545 using Tapatalk

 

[vapdivrr]

0.7 ohm 26g micro coil with cotton

Sent from my SCH-I545 using Tapatalk

I also have a kayfun with this very same set up which I do enjoy but prefer the twisted 27g better because I am able to obtain a little more power into it with the dna. Maybe try some twisted 27g and resistance of .6. If done right it will be a little slower but because of increased wick coverage should produce more vapor.

Sent from my SCH-I545 using Tapatalk

 

[Joka]

It will be a little while before I can get a drill for twisting. I have nothing like that just laying around. I've been curious about it tho since the first time I seen them

Sent from my SCH-I545 using Tapatalk