Keep Blowing Attys! Help!

[MBblue]

I keep blowing attys on my Chameleon when I'm using it as a 6v or 7.4v device. I have zero problems when using it as a 3.7v device though. I even fryed a high voltage 901 atty on it.I have plenty of liquid on the atty and it lets me take 1 or 2 really harsh drags, then it just stops working. At this point the atomizer is dead and won't work on the Chameleon or any other device. This obviously really sucks because I want that 6v sweet spot but I don't want to keep blowing attys trying to figure this issue out. Someone please help! I'm stumped.

 

[Hoosier]

Can you find a HV, High Voltage, atty for the 901?

They should have a thicker and shorter heating coil to take the increased voltage without breaking.

I know there are HV 510's, since that is what I use, but do not keep up with the 901 hardware.

I am sure someone more in the 901's will be here soon...

 

[HzG8rGrl]

I have a chameleon and use 901's all the time. Can't lay on the button is what I have found out. I never had a problem with blowing atties until I went through an extremely stressfull couple weeks. I was laying on the button (long hard hits) too much. Also, make sure you are using 2-3v batteries and not 2- 3.6v batteries. Posts this in ikens subforum and maybe you can get some more thoughts on this issue.
HTH

 

[MBblue]

Thanks for the tips. I'll try Iken's subforum.