Kicks
- Thread starter roosterado
- Start date
- th_trl_thread_readers 0
- Status
I found this a Vaperev
Evolv Kick V2
The Kick "Version 2", has been upgraded using solid brass negative contacts, allowing the unit to have less chance of voltage loss or faulty ground connections. Version 2 is also capable of now running between 5 up to 15 watts!
Evolv Kick V2
The Kick "Version 2", has been upgraded using solid brass negative contacts, allowing the unit to have less chance of voltage loss or faulty ground connections. Version 2 is also capable of now running between 5 up to 15 watts!
Last edited:
I am also looking at the Sigelei. How does its performance compare to the Evolve Kick2?
The price is attractive @ FT.
It would be nice to kick my Nemesis/Kayfun to get a consistant vape over the full usable voltage range of my battery.
The price is attractive @ FT.
It would be nice to kick my Nemesis/Kayfun to get a consistant vape over the full usable voltage range of my battery.
Last edited:
From what I've read (secondhand info alert), the clones from Sigelei and Smoktech use a 33.3Hz PWM chip, while the Evlov Kicks are DC to DC. This might make the vape you get from the Evolv Kick smoother. I bit the bullet and bought a Evolv Kick 2. So far, it's working great.
Last edited:
If the clones are pulse width modulated at 33.3Hz then according to PBusardo that could cause the rattlesnake noise from a tank when inhaling. Thus the Evolv Kick would be a smoother draw
Fasttech kicks work very well. I have 6 and no issues. I use their 12w version.
No rattlesnake noises noticed on any of these. 4 are running Kayfun tanks between 1.3-1.6ohms
No rattlesnake noises noticed on any of these. 4 are running Kayfun tanks between 1.3-1.6ohms
It's not just the noises though. I was vaping on a zmax and didn't here a noise at all; but, it tastes horrible burnt on a fresh wick and coil. Couldn't been just the juice as it was a coffee flavor; but turned me off from pwm devices for sure
Sent from my iPhone using Tapatalk
You do know that ProVaris are PWM as well, just a higher rate. 800Hz vs 33.3Hz.
Yeah I know, by default all regulated mods are. Just different frequencies. There is a huge difference though between 800hz and 33.3hz
Provari is at 800hz the MVP2.0 and the v3 is at 730hz, I believe. The 800hz cycle on the provari looks dc because it's so fast, which is why allot of people say it's straight Dc, the reality is it's not. That 33.3 is just so low and the cycle is so extreme that I can taste the burn in certain juices. It's my palet, I spent 23 years as a chef and I'm one of those people that can pick apart a recipe, so, I can taste all kinds of differences In things. It also makes me picky on juices; which sucks.
Sent from my iPhone using Tapatalk
Last edited:
I have a Evolv Kick V2 (5W-15W) and a SmokTech Kick (5W-12W). I can't tell the difference between them! I bought the Evolv Kick V2 as an Up-Grade, but received an equivalent vape experience.
Mech. MOD: Dominus Fecit w/ Lord's Up-Grade RBA:KFL+ 32awg,2.5mm silica @ 1.9ohm W/ Kick@10W
Last edited:
- Status
Similar threads
