Well I Have had my lavatube for about a month now I started off with 2.5ohm dual coil carts in my tank. I just bought some 3.0 Single coil cart for my tank and things are starting to act weird when I put my voltage higher than around 4.1 volts when vaping the screen dims and blinks at higher voltages. I know the batteries are charged when reading the voltage out of the lava tube it reads 4.1 and I have been taking them on and off the charger. I'm not sure whats up if its the cartomizers or my batteries but It shouldn't be the batteries they are maybe a month old any suggestions? I really dig this Mod Maybe a new tank idk
LavaTube Troubleshooting? Screen Flashing
- Thread starter Frostedflames
- Start date
- th_trl_thread_readers 0
- Status
I'm using red imr 18650 3.7v 1600mah batteries from liberty flights and smoke tech 3.0ohm and I don't have a multimeter :/
Last edited:
a vaper without a meter is like a fish without worms...sure you can eat, but it won't be as tasty.
Pick up a cheap meter. Many, many vape stores and even bargain stores sell them for 10$ or under.
Pick up a cheap meter. Many, many vape stores and even bargain stores sell them for 10$ or under.
If you got your Lavatube from Volcano, they have a full 1 year warranty. Just open a ticket with them for replacement/checking. If it is not your batteries, then something is probably wrong with the unit. If you got it from another vendor, check with them re: warranty. 
Way to point out the obvious, great post.
The batteries come off the charger and are less than a month old they aren't dead maybe bad idk.Planning on picking up a multimeter, new battery and a few cartomizers to test things out I think it may have to do with the cartomizers I am using. I got the Lavatube from Liberty Flights so If it doesn't work I think they have a 3 month warranty.
Anyone know of a good tank to use with the lavatube that wont be limited I was recommended "vision stone tanks" before but not sure if they will work well on this mod
Last edited:
I would contact the vendor through there support about the issue..I know "LT's" have short circuit protection so maybe it's a short in the coils or maybe an issue with the device itself. I've never heard of this issue so IDK if screen flashing has to do with a short or not..you could try another cartomizer to see if you still get the issue too..is this a V1 "LT" or a different version with the ohm meter? I ask because they could be different also...
I can hit the power button five times to get a read out of the batteries so I think its a v2. This really just started on these 3.0 Single coil carts I was checking out this acorn Acorn Tank 2.8-3.0 Ohm But because of the problems with running dual coils im worried that this wouldn't be hitting the higher voltages. Any input on these?
the battery remaining is a feature on the V1 - V3 LT's. 510 connector=V1, ego connector=V2 - likely you would know if it was a V3.
There is a batch of LT's running around that seem to have the flashing screen issue (usually with any carto under 2.0 Ohm). I would open a ticket and send that one in.
There is a batch of LT's running around that seem to have the flashing screen issue (usually with any carto under 2.0 Ohm). I would open a ticket and send that one in.
- Status
