Lave Tube, new and no vapor?

[SuperDrifter439]

I'm trying to figure out what I'm doing wrong. There was some vapor when I first got the package unwrapped, and put the carto? and drip tip on. After that I put some (10 drops) into the tip, now I can't get ANY smoke.

Battery is full charge
Made sure the carto seal was free was making good contact with the battery

Any help would be great, I know this is capable of producing some serious vapor, just haven't seen it yet...!!

Thanks

ps. I was able to refill my green smoke, and it works great.... 15 flavs tomorrow to try.

 

[Stef64]

Are you using a cartomizer or an atomizer? The LT kits come with atomizers AFAIK. If you put 10 drops into the atomizer and you get some flavor but no vapor it is possible that you flooded the atty. Just blow the juice out from the battery end and you should be good. If that is not the case, give us a little more info.

Good Luck...

 

[muzichead]

Just a quick question, did you charge the batteries prior to using or did you use it straight out of the box? I believe all vendors require you charge the batteries fully prior to using the unit. Also keep in mind, (since you did say carto), I will assume you are actually using a carto and they usually take more than 10 drops to fill them up. I believe most people use a syringe or a bottle with a syringe top to fill carto's. Just a thought.....

 

[SuperDrifter439]

So it is an atomizer... ok tested the battery with another cart and battery work, so it must be the atomizer. I did blow out the end and cleared it, but still nothing.

What info could give you? I'll try to dry it out well and try it later..

Thanks

 

[muzichead]

Since this is a LT and you have figured out it is in fact an atty, what voltage do you have the LT set at and what ohm rating is your atty? I believe I have read the LT has a cutoff voltage depending what resistance of atty you are using.

 

[SuperDrifter439]

Since this is a LT and you have figured out it is in fact an atty, what voltage do you have the LT set at and what ohm rating is your atty? I believe I have read the LT has a cutoff voltage depending what resistance of atty you are using.

Yeah Seen the YouTube vids, reviewing the lava, and they say, it cuts off at 3.2 for LR's. Tried all different volts w/o success. The atty on the kit is probably rated higher, but I tried it @ diff. volts. I've narrowed it down to the atty, though. I had a separate working cart, and it worked on the lava.

 

[muzichead]

You might want to check over at the LavaTube section of the forum and maybe you can get a better answer to your problem.

Lavatube

 

[SuperDrifter439]

I will thx