Lemo 2 problem.

[littleblue]

I absolutely loved my new Lemo 2, until I knocked it and the istick 50 off the table. Now it won't fire, says no atomizer on both the istick and the ohm meter. I put a new coil and it still doesn't fire or read. Any ideas as to what the problem might be. It landed on straight on the drip tip.
Thanks for any help.

 

[VaPreis]

Could be a contact issue with the lower base section. I had that problem with one of mine and I unscrewed the lower portion and re-installed it and it hasn't been a problem since. Once apart, you might also check to see that your coil is properly secured and that the center screw is fully tightened into the positive block.

 

[littleblue]

Does the base (510 connector & air adjustment ) come apart? The base plate does seem a little wonkie.

 

[Wolfenstark]

Something is not making a connection , have to go through it all.
Wires on your build making a connection with the screws or holes whichever your using. 510 at the bottom making connection with your mod.
Many times the 510 on my lemo gets screwed back inside after putting it on my mod a few times.
The very bottom of the lemo screws off thats where you get to the fill screw , least in version1.

 

[littleblue]

Thanks for the replies. I found a way to adjust the 510, but it just retracts when I screw it on to a mod or ohm meter, so I guess I broke it.
Thanks for the help.

 

[roxynoodle]

Try putting a 2 x 1 o ring on your 510 pin. That should help to keep it from moving. You can take one off those little keychain screwdrivers if you don't have any.

Also, check your positive block isn't crooked, and is fully tightened down.

 

[littleblue]

Thank you. It didn't work for mine, I think the bottom plate is out of whack. Also, thanks for telling me where to find the o rings. I would never thought of looking there.

 

[littleblue]

Thanks to all for your help. My son fixed it by pushing the bottom pieces back together. I'm a happy camper now.

 

[foxracing088]

Had the same problem when I dropped mine... finally figured out that the base had come loose somehow... had to press the very bottom base together with some pliers... Works great now