Lemo adjustable screw not making contact

[jcutler123]

I have finally got the lemo to taste good after a month a messing with it. The problem I have now is the adjustable screw on the bottom is so loose it always screws back down when attaching it to the istick and it doesnt make contact with the 510. I would have thought both of these devices being made by the same company that everything would line up well. My question is what is the best way to fix the loose screw problem. Should I try a small o-ring or is there another way? Who carries o-rings that small? Not sure but I dont think Home Depot or Lowes carry o-rings that small but I may be wrong. Is there an online vendor? Thanks

 

[NOVA jon]

If you have a kayfun, the fill screw o ring should work, or the small screwdriver you get that has a Phillips on one end and flat on the other, that little o ring is what I used on one of mine that was a little wonky.

Not sure what size it is but you can find all size o rings at orings.com

 

[jcutler123]

If you have a kayfun, the fill screw o ring should work, or the small screwdriver you get that has a Phillips on one end and flat on the other, that little o ring is what I used on one of mine that was a little wonky.

Not sure what size it is but you can find all size o rings at orings.com

Is the o ring on the screw driver?

 

[Romano Cheese]

I read this on a different thread can't remember where but if you have an old protank coil take the rubber insulator out of the bottom and cut the end of it off it makes for a perfect o-ring for the 510 screw

 

[roxynoodle]

2 x 1 metric o rings seem to work well on all 510 pins