Lemon Creamsicle

Status
Not open for further replies.

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
If you love Lemon this DIY is simply smooth creamy sweet lemony goodness...

Total flavoring 20%

Lemon (w/s) (TFA) 8%
Vanilla Swirl (TFA) 5%
Vanilla Custard (FW) 3%
Ethyl Maltol 10% diluted (TFA) 4%*

Base of your choice (8mg/ml Nic 70PG/30VG typically for my mixes)

*I'm on the fence whether my percentage of Ethyl Maltol is a little high, it's good as is but that little nagging voice just wants to play a little more. Maybe EM 2% and bring back up the sweetness with TPA Sweetner as needed...

Next in line for one of my tanks, too many juices not enough tanks :glare:, hope you enjoy :)
 

dmall

Senior Member
Supporting Member
ECF Veteran
Dec 13, 2012
261
241
New Orleans, La
If you love Lemon this DIY is simply smooth creamy sweet lemony goodness...

Total flavoring 20%

Lemon (w/s) (TFA) 8%
Vanilla Swirl (TFA) 5%
Vanilla Custard (FW) 3%
Ethyl Maltol 10% diluted (TFA) 4%*

Base of your choice (8mg/ml Nic 70PG/30VG typically for my mixes)

*I'm on the fence whether my percentage of Ethyl Maltol is a little high, it's good as is but that little nagging voice just wants to play a little more. Maybe EM 2% and bring back up the sweetness with TPA Sweetner as needed...

Next in line for one of my tanks, too many juices not enough tanks :glare:, hope you enjoy :)

THis looks great don't have the EM gonna use TFA Sweetner instead.
 

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
Ok, have to admit, I posted a little early on this :oops: typically I finish-off a 30ml bottle, fully steeped using a carto tank as the delivery device. That said the creamy-side overtook the lemon and became a minor note of the juice, so I am increasing the lemon 2% and cutting back on the Ethyl Maltol (or Cotton Candy) 2% the next time I mix. If it takes a third attempt :glare: to get just what I'm looking for the two Vanilla components will each be trimmed by 1%.

So now I'll be mixing at:

Total flavoring 20%

Lemon (w/s) (TFA) 10%
Vanilla Swirl (TFA) 5%
Vanilla Custard (FW) 3%
Ethyl Maltol 10% diluted (TFA) 2%

Sorry for the over exuberance :blush:
 

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
I'm guessing it means water soluble? It sounds like a really good recipe. The only lemon I have is lemon sicily. See? This happens every time. I'm going to end up with hundreds of flavors. lol

Bingo :D

Sorry I forget sometimes the aberrations aren't that obvious (w/s) is water-soluble :oops:

I hate to say it I haven't had a chance to make up that second batch yet, just been a little too busy around my neck-of-the-woods, so please let me know...

Hope you all enjoy :)
 

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
Finally got around to mixing today, this was one of seven on my list to get done. Mixed at the 2nd previously posted percentages...

Total flavoring 20%

Lemon (w/s) (TFA) 10%
Vanilla Swirl (TFA) 5%
Vanilla Custard (FW) 3%
Ethyl Maltol 10% diluted (TFA) 2%

Will post my thoughts about how this ratio turns out after steeping and running through one of my carto tanks :)
 
  • Winner
Reactions: mightymen

Uno mas

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 5, 2013
9,199
30,440
San Antonio, TX
Final recipe, for real ;)

Added 2% Lemon on 4/22 after dripping...

Finished off a full tank this afternoon and I love it :thumb: the lemon does come out now but smooth and nice...

Total flavoring 22%

Lemon (w/s) (TFA) 12%
Vanilla Swirl (TFA) 5%
Vanilla Custard (FW) 3%
Ethyl Maltol 10% diluted (TFA) 2%

This will be a keeper, hope you give it a try :D
 
Status
Not open for further replies.

Users who are viewing this thread