I got some 28G 316L SS wire earlier this week and I think I got a little bit too thin of a wire.... I have ordered some thicker 24g and 26g but until I get them could someone recommend a good build for a dual coil on a Billow V1 rta?
Right now I have about 8 wraps around a 2mm for about 0.5 Ohm.... I would like to achieve if possible somewhere closer to 0.2-0.3 Ohm but with the resistance of the 28G a little higher than I was expecting it is hard to only wrap the coil 4-5 times cause I dont really think that it'd be big enough length wise to heat up enough wick for good vapor production. Im wicking with rayon.
Thanks
Right now I have about 8 wraps around a 2mm for about 0.5 Ohm.... I would like to achieve if possible somewhere closer to 0.2-0.3 Ohm but with the resistance of the 28G a little higher than I was expecting it is hard to only wrap the coil 4-5 times cause I dont really think that it'd be big enough length wise to heat up enough wick for good vapor production. Im wicking with rayon.
Thanks