Lowering ohms?

[Jelen88]

So I'm about a week into rebuilding. I have an rsst and an igo-w4. I have the igo set up with a dual coil with 4 wraps with 28 gauge kanthal. The ohm check says I'm running at .6 ohms and I would like to get it lower. And the rsst has a 3/2 wrap and it is vaping at .9 ohms. I would also like to get this lower. Do I just need to do less wraps or what?

 

[Dakota Jim]

I am so sorry, but if you need to ask

you should not be building subohm coils

"just because we can does not mean we should" quoted from Baditude's battery safety blog

 

[suspectK]

Try wrapping the coils together. Using a micro coil might show you that you don't need to get that low into deciohms.

Edit..and jim posted right before I did. I fully agree with that.

 

[sloR3X]

Some basic understanding on resistance will go a long way. I'm no expert but I would have to agree, if you're asking, you probably shouldn't be doing it.

 

[Jelen88]

Wow sounds kinda dickish. My could are actually built very nicely. Just hope you have a simple question and someone blows you off. Hve a good day

 

[polpol]

Wow sounds kinda dickish. My could are actually built very nicely. Just hope you have a simple question and someone blows you off. Hve a good day

Nah man. It's just everyone's hesitant to teach you how to explode most batteries. Now if you could explain how you're vaping safely, amp limit and chemistry of your battery, whether or not your mod has hot springs or vent holes; then you'd have come across the answers to your question anyways.

No TLDR when it comes to safety.
Edit: fixed wrong quote

tapatalk