Lung Hitting tank

[Dlovell]

Reo all day. I drive for a living and it's the only mod I use at work. It's simple, holds a ton of juice, and looks great. I have mine running a .4 dual coil. 34 watts at 3.7v. dna can't do that.

 

[Elizabeth Baldwin]

I'm a big lung hitter. I take deep long inhales. I took the air screw completely out of my Russians. Works good. I also have a Fogger V4 and it gives good lung hits too.

 

[Bunnykiller]

Im primarily doing lung draws... and the RSST is keeping up with the demands. I drilled out the air hole and set the wicking up with 3mm silica in the tank feeding a cotton bed on the build deck with a nano coil in horizontal mode laying in the cotton. The wick stays "dripper" wet and the wet cotton keeps the hole the wick is in from leaking when layed down ( dont forget to insert filler plug )

works like a charm

 

[Coppercustomz]

Kanger mega aerotank its simple & pretty open, I take lung hits all day with it

 

[Dochartaigh]

When I first drilled it out, I thought it made a huge difference, but when I compare it to the one I got from fatdaddy, there isn't too much of a difference. So maybe not all pins are created equally...

I second getting the FatDaddyVapes center pin for a Kayfun, and drilling out the side airhole just a little bit (takes 30 seconds).

I previously only used Kayfun 3.1's since they have MUCH better airflow than the KFL/KFL+/91% (those just sat in my gear bin because of their restrictive airflow). I then installed the FDV center pin on my unused KFL/KFL+/91%'s and they now get lung hit all day long. It makes them worlds better.

The new KFL+ V2 (has to be V2) from FastTech also has a much better airflow than any previous model I've used and is fine for lung hits.

 

[MrPlink]

A reo has been on my list for a while to get. I just wish they had a DNA 30 version. Been using my hana exclusively since I got it, my mechs just sit around. I have a richman hybrid and a prometheus but haven't been able to get them to wick properly. Always end up with dry hits and hot legs whether I use cotton, stainless, or both. I would probably love them if I could get them to work well.

Maybe I should look into the reo with the low resistance kit...

Look into the Sunbox E7 from Italy, bottom feed dripper controlled via Dna30. Not cheap at about 350USD, but on paper it is a dream device.

 

[vapdivrr]

Look into the Sunbox E7 from Italy, bottom feed dripper controlled via Dna30. Not cheap at about 350USD, but on paper it is a dream device.

That is a dream device for sure and will probably be my next mod. most likely, being made in Italy, should be of great quality as well.

Sent from my SCH-I545 using Tapatalk