Max VG for subtank mini RBA

Status
Not open for further replies.

deadmadeuces

New Member
Dec 21, 2016
3
0
28
First of all, I'm new here so hello :)

Second of all, I recently purchased The Milkman Churrios 6mg and am trying to find out what's the best setup for the rba V3. So far i've done .44 vertical 3mm ID parallel 26ga kanthal, .7 3mm ID spaced kanthal and nothing works. All i got was tasteless hits and the vapor smells like joss sticks to me. Can you guys give some suggestions? preferably using 26ga kanthal, thanks in advance.
 

BreSha6869

Vaping Master
ECF Veteran
Verified Member
Nov 21, 2015
4,876
18,564
56
Toronto, Canada
I do a 26-28ga horizontal kanthal coil at about 0.5-0.6ohms. I use cotton or rayon and leave about 1cm on each side of the coil, put the rba tube back on, use a small screwdriver to carefully push the wick down to ensure the feed holes are covered but not packed too tight, wet the wick, fill, reassemble, a few fake draws to get the juice moving, wait a min and start wattage low for a few puffs until I get to desired wattage.

I find the Kanger RBA works best with 20%+ PG, but will work with max VG as long as you don't chain vape.
 

srg2692

Senior Member
Verified Member
May 5, 2016
70
40
33
Ah the Kanger RBA. It's what got me into building. It's been over a year since I've used it, but I still think it gave some of the best flavor I've had. IIRC I had the best luck with a 22g spaced coil at 3mm ID at 50 watts. I don't recall the amount of wraps, but probably 5-7. A coil that wide will restrict the airflow a fair amount, but the flavor is exceptional. I also used 24g occasionally but the 22 was best. 26 would probably perform best twisted in that particular atty.
 

deadmadeuces

New Member
Dec 21, 2016
3
0
28
I've found the V3 RBA (smaller hole, high off the deck) doesn't wick higher VG as well as the V2, or a modified V1.
My typical build is with 26g, .6-.8 ohm.

From my experience last year, i had most luck using V3 rba but using 26ga ni200 since the juice holes looks like it had the most flow compared to the V2 rba.
 
Status
Not open for further replies.

Users who are viewing this thread