Mechanical Mods

[Plumes.91]

A rebuildable atomizer at 1.5 ohms at 4-5 volts is pretty damn good too.
Hell I like 1.5 ohms with a battery fresh charge in a mechanical for hours.
As the time goes on, you take longer hits or change the battery.
In a regulated mod, you dont have to worry about the battery discharging.

 

[LKnives]

I would suggest buying a SmokTech Natural and some 1.7 Ikenvape single coil cartos or LR attys and trying it. If you don't like it you can get most of your money back selling it in the classies. I am running an AC9 on a Natural right now and it is phenomenal. I am also running a 1.7 single coil carto in a Fluid Flask on another mechanical and it is great as well. I also have 3 kicks, a ProVari and a VV Saber Touch, the mechanicals give as good a vaping experience as any of them when set up properly.

Was looking at the Natural on Gotvapes and the turn off was that it said the Kanger T3 didn't work on it and that is my most used delivery system.

 

[Fullknight]

It will work with 510 to Ego adapter.


Sent from my iPhone using Tapatalk

 

[LKnives]

You have a different definition of "working" than I do. Or I am totally biased by a bad experience I had a 510 to eGo adapter I had.

 

[Fullknight]

I have several. Never any problems


Sent from my iPhone using Tapatalk

 

[LKnives]

Mine was cheap. Was using it to vape my Kanger T3 on my, I think V1, Lavatube and after the heating and cooling process happened to it a few times it became a permanent part of the Kanger base. Might've been because of my inexperience at the time or just bad design but I haven't use a 510 to eGo adapter since and just stray away from things that don't natively work with the T3s.

 

[StaircaseWit]

For another perspective, you don't have to run super-low-resistance coils on a mech mod to get a good vape for most people. I run 1.5-1.3 ohm coils in an IGO-L on my iSeason and the vape is great for hours. It's significantly smaller and pocket-friendly than any regulated mod that uses the same batteries so I tend to use it as an out-of-the-house mod and use my Provari at home. I'm glad I got into mech mods because if anything fails anytime soon, I have a basic battery tube to fall back on. As long as there's a battery that works, I can make the mod work -- there are no wires and the switch is three pieces of metal that screw together.

 

[muzichead]

Mine was cheap. Was using it to vape my Kanger T3 on my, I think V1, Lavatube and after the heating and cooling process happened to it a few times it became a permanent part of the Kanger base. Might've been because of my inexperience at the time or just bad design but I haven't use a 510 to eGo adapter since and just stray away from things that don't natively work with the T3s.

I would tend to lean to the side of human error,(ie. hulk strength), for this situation and you just cranked it down a little too much....lol