Mechanical reos will be seeing some upgrades
- Thread starter redeyedancer
- Start date
- th_trl_thread_readers 0
- Status
Ordered 2 kits. Less than 50 left. Now comes the waiting game for the Fitting of the mods so I can finally pull the trigger on one of them there sexypants LP jawns.
I doubt he'll go through 10,000 of them in a week. I think you'll be fine. But then again I'm not waiting.
"Do you feel lucky ..., Well do you?"
I may have misspoken, only 51 left.
Edit: make that 49 left
Oh, and Rob...I really hope that you use Stamps.com or some other service where they come pick the packages up from you. Otherwise your car is going to look like the Clampett mobile hauling all of our treasures down to the post office.
Rob told me the Mini 2.1 kit would be available about a week after the kit for the Grand. Hoping for individual springs too.
I have a feeling Rob is being swamped by PMs by now (mine being one of them). I've never been this excited for a few strips of metal. 
Sooo wanted to order a new Grand today....guess I'll just have to be happy with my Woodvil until Rob gets the SO kits into his current stock.
I have a question about installing the subohm kit.
When he pulls the rubber tube off, he grabs the metal part and says "grab with pliers and break off"... does that mean that pin cannot be reused because it's been broken? Or is that just how it comes apart, but can snap back on? Just didn't know if that was a discardable part.
Also, will this kit work for a woodvil too?
When he pulls the rubber tube off, he grabs the metal part and says "grab with pliers and break off"... does that mean that pin cannot be reused because it's been broken? Or is that just how it comes apart, but can snap back on? Just didn't know if that was a discardable part.
Also, will this kit work for a woodvil too?
It is threaded on, I've been able to take them apart by holding it with pliers and then using a flat blade screw driver from the top on the center pin.
For the Woodvil the only piece that will work is the spring, so I plan to wait until just the new springs are listed and order those for the Woodvil, it will require some soldering to replace the spring on a Woodvil.
For the Woodvil the only piece that will work is the spring, so I plan to wait until just the new springs are listed and order those for the Woodvil, it will require some soldering to replace the spring on a Woodvil.
so is the the metal squonk tube, nipple and gaskets definite included cus it doesn't show those parts at the pic
It says it has everything we need to rebuild a Grand. I guess it should include them.
If you break the pin off, which he shows, no, you cant reuse it but you dont have to because a new one is supplied. Breaking it is the fastest way to push the pin up and out of the connector instead of trying to unscrew it. Guess you could if you wanted to unscrew it and then push up and out of the connector..
Sometimes yes, sometimes no. It can snap unscrewing it sometimes. Always have a spare handy if trying to unscrew it.
- Status
