Merged old sticky threads (3)

[Elendil]

Got some Janty RY4 carts with my stick. It was my first experience with RY4 and it is great. I see the Janty site sells RY4 carts, but I dont see any bulk liquid in RY4(even out of stock)..........

Does Janty sell RY4 in bulk, and if not, when can I get exactly the same RY4? (I know not all RY4 is the same)............

 

[gr8dane]

With my non-stick PVs I've always oriented the cart so that it lines up with the wick when I put it on the atty. This doesn't work with the stick and flat mouthpiece. Today I twisted the cart, so I wasn't having to use it at a weird angle, and immediately melted the end of the cart. Any suggestions?

 

[Rorschach]

As i understand it, the first RY4 that came on the market way back when was from Janty. so I know they sell it. For awhile only THEY had it. Strange that it's not on the site.

 

[jcgearhart]

This is my first 801 atty also. I love the performance of the stick. I think it needs to use more liquid to perform at this level. However, I have noticed that the 801 cart is sloppy compared to the 901 and Dura carts and drip down on the mouthpiece when I refill, at least 2 dropsworth are wasted every time I top off the cart. That could contribute alot to an increase in liquid consumption. Have you noticed this and is it typical of the 801 carts?

 

[Sun Vaporer]

Welcome to the Penstyle good people --the 801's are all gas guzzlers!!!!! But like a good race car--"they are worth the drive"!!!-------Sun

 

[borjis]

We have a HUGE order of liquid coming next week.

chocolate? I'm really jonesing for more chocolate only have a little bit left.

 

[Kate51]

They are guzzlers, all right, but I think the Stick outdoes them! Wow, I went through approx 7ml yesterday and today. Yah, I'm playing!~The 801 with fresh new batteries would drink up juice awfully fast, and someone asked if they drink them dry, they do. The stick seems to pull the front moreso, but I think that may be I'm puffing more often than even normal. My AUTO seems to be a little cantakerous, sometimes cuts off too fast, won't let me draw more than 2-3 seconds. After I let it sit a couple minutes, the next draw is fine. It's got a little quirk, sometimes have to give it a little pull just to get it heating, then another pull for vapor. Might just be it's just in the circuit board and I'm not used to it yet. But when I can get it to heat long enough it really burns up the juice. Overheating? It definitely can spoil my juice taste, going to try one a little stronger, be here tomorrow. Had to go to VG, my throat couldn't take the PG anymore. It really leaves a kind of oily feel on exhale to my taster. Makes me want to go brush my teeth. Does anyone know if the VG burns faster than PG???? It's been a LOOOOONG time since I had a really good battery, these are outstanding so far, I'm only on my 3rd charge right now. (Wall charger). Just incredible life, and good power life from beginning to end, no fading away like the 801's did. I'm using Jantys atty, going to stick with it to see how long it will last with good battery power.
There's NO WAY I can pull long enough to turn it RED!! Whew!

I still think the poor batts 801s is what burned out so many attys! I swear! I believe myself when I think that. SUE THEM, I spent a fortune on those darned things.
Anyway, G'night all, gotta long day tomorrow. WORK, ALL LA TIME WORK

 

[deewal]

With my non-stick PVs I've always oriented the cart so that it lines up with the wick when I put it on the atty. This doesn't work with the stick and flat mouthpiece. Today I twisted the cart, so I wasn't having to use it at a weird angle, and immediately melted the end of the cart. Any suggestions?

yes i've noticed that too. Not perfect is it ? The only sure way to have the cart lined up is too have it at a weird angle.

 

[Katoo]

want!

Tired of waiting!

 

[Ethan_Janty]

Just a reminder, I will not be in the office today, so I will be forwarding all emails sent to me to Info@jantyusa.com. I'll do my best to check in every now and then.

Ethan

 

[FlaCracker]

The part of the cart that holds the packing will rotate independently of the mouthpiece.

Jimmy

 

[Cellmeister]

Check The Other Janty Thread. I am Sure I Read Yesterday That JantyUSA May Ship To Customers Today or Tomorrow, I Am Waiting For My LE As Well (I do have the SE One).

Please Don't Quote Me On That.

But I Can Tell You Its Worth The Wait!

~Keep Vapin~!

 

[Cellmeister]

With my non-stick PVs I've always oriented the cart so that it lines up with the wick when I put it on the atty. This doesn't work with the stick and flat mouthpiece. Today I twisted the cart, so I wasn't having to use it at a weird angle, and immediately melted the end of the cart. Any suggestions?

I Have Had Mine For A Little While Now, No Issue Like That. I Don't Know How U Say It Doesn't Work, There Are Hundreds Of Sticks Out.

Also Did U Mean U Burn't The Filler and Not The Edge of The Plastic Cart?

IF The Cart Was Not Put In Straight Of Course You Will Have This Issue...

I Know What U Mean About Aligning the Cart To The Atom But Have Not Had Any Issue Like That Yet.

But I Look At The Filler Depression 1st and Then Turn The Filler With Tweezers Inside The Cart To Be Straight & Aligned With The Atom, Then Just Press it In Straight. As Long As Its Set Up Like That Its Fine To Keep Pulling It Out Straight and Refilling And Placing It Back In Straight Again (its easy just look 1st). You Will Only Have To Check/Turn/Align it Again If You Have Turned The Cart, Otherwise Starlight In On & Off Its Fine.

FYI: I Must Have Pulled Out & Filled Janty Stick Carts Up Close To A Thousand Times Now!

Just A Thought & Question, Are U Using The Janty Carts?

Maybe Try Putting The Cart In Straight & Fully Inserted and ? Or Try Another Cart.

Hope It Helps.

My Stick Rocks!

~Keep Vapin~!

 

[Lane]

Hi everyone, I tried charging my stick batteries yesterday with my puresmoker e cigar battery charger(input:100-240V~50/60Hz, Output: 4.2V_200mA) and after about 15-30 mins the light stayed red and the battery and the charger got pretty warm, so of course I discontinued that. This charger charges my other e-gar batts fine. Is the separate charger from Janty different then the other e-cigar chargers? Has anyone else run into any problems trying to charge the stick batts on a generic e cigar battery charger? I'll get the one from Janty if needed but I didn't think it would be necessary.. Any insight would be greatly appreciated, thanks guys...~Lane

 

[Katoo]

I know, I know. I am just getting antsy.

 

[hanover fist]

This is my first 801 atty also. I love the performance of the stick. I think it needs to use more liquid to perform at this level. However, I have noticed that the 801 cart is sloppy compared to the 901 and Dura carts and drip down on the mouthpiece when I refill, at least 2 dropsworth are wasted every time I top off the cart. That could contribute alot to an increase in liquid consumption. Have you noticed this and is it typical of the 801 carts?

Strange my KB rarely gets liquid in the mouth piece I take out the batting clean it, fill the cart to the top then put the batting back in. the batting doesn’t displace the liquid when I stuff it back in the full cart.

 

[jcgearhart]

When I pull out the cart, the white plastic is coated with liquid on the outside and it runs down onto my fingers and the mouthpiece as I'm topping off the cart. It is a significant amount and I now use a Kleenex to clean it before I top off. Seems like a waste of juice. This is my experience with the 801 cart. But I love the capacity of it and top off alot less often.

 

[LuckySevens4U]

Any mod you use or a passthrough with a power pack is going to suck more juice. They all do it.

 

[ArizonaVapin]

When I pull out the cart, the white plastic is coated with liquid on the outside and it runs down onto my fingers and the mouthpiece as I'm topping off the cart. It is a significant amount and I now use a Kleenex to clean it before I top off. Seems like a waste of juice. This is my experience with the 801 cart. But I love the capacity of it and top off alot less often.

This is the problem I have with 801 carts as well. Most of the liquid is most likely being wasted by wiping the sides of the cart. That is why I am eagerly anticipating adapters for other models.

 

[jcgearhart]

Thanks AV. I was wondering if it was just me. I have not had any liquid in the mouthpiece or had a mouthful of liquid yet. Just a mess when I remove the cart. I do have a straw mod working in the cart and thought that might be the problem. But I have 2 Juanty sticks and the regular cart on the other goes the same.