Hi guys..
Should there be a safety cutoff for the dna 40 mods when in temp mode? As we all know it uses different wire(ni200) as oppose to khantel.
When there is a mid-reading on the resistance due to loose contacts it usually jumps back the vv mode and continues to fire the coil.. But when we fire ni200 wire in regular mode it goes into high heat, giving off foul vapor and I read somewhere possibly toxic vapor as well.. For a usually lung hitter I can't tell till too late;(
And it doesn't help that some mods the display are at the side or bottom, where u can't read when vaping..
So the question is when in TC mode shouldn't it stops when it detects irregularities in resistance reading, rather than continues in vv mode?
Should there be a safety cutoff for the dna 40 mods when in temp mode? As we all know it uses different wire(ni200) as oppose to khantel.
When there is a mid-reading on the resistance due to loose contacts it usually jumps back the vv mode and continues to fire the coil.. But when we fire ni200 wire in regular mode it goes into high heat, giving off foul vapor and I read somewhere possibly toxic vapor as well.. For a usually lung hitter I can't tell till too late;(
And it doesn't help that some mods the display are at the side or bottom, where u can't read when vaping..
So the question is when in TC mode shouldn't it stops when it detects irregularities in resistance reading, rather than continues in vv mode?
Last edited: