Hey everyone!!! I need a little help using a multi meter. I just got one and I can't figure out how to check the output voltage from my variable voltage box mod. Any advice would be greatly appreciated.
multi meter on box mods
- Thread starter hatfieldsmama
- Start date
- th_trl_thread_readers 0
- Status
touch the red tip to the center pole in the connector and touch the black to the outer ring and fire it, its tricky because ideally you would have to use 3 hands, but its doable lol
If you have an old clearomizer, remove the plastic tube. Touch the base of the clearomizer with the black lead, red lead goes on the center metal tube.
You can also solder an alligator clip on the end of a wire; solder the other end of the wire to the clearo base; repeat w/ wire/clip for the center metal tube.
Sent from my iPod touch using Tapa-tapa-tapa-tapatalk
You can also solder an alligator clip on the end of a wire; solder the other end of the wire to the clearo base; repeat w/ wire/clip for the center metal tube.
Sent from my iPod touch using Tapa-tapa-tapa-tapatalk
Last edited:
- Status
Similar threads
