Multiple coil runs on RBA!

[StrappedKaos]

Hey Pro's,

Got an odd question/Idea....
If anyone has ever upgrade valve springs on an over head cam engine they prob. have seen my idea, SO I was thinking last night if this would work as I dream about cars and thats where I invisioned it lol.
Valve Spring Set for Racing Valve Springs
THey are made to allow stiffer valves while saving space and valve train walk issues..I know not of importance but can I wrap a coil this way to increase ohm and still cover a wick without the micro wrap idea. Sounds dumb but don't use mech. mods and have a vamo so prefer 2+ ohm coil. Did I just come up with the next best thing or should I not try this and what is issue with touching coils if I didn't wrap right? would it cause huge issues?
Could you use this idea to wrap a large wick inside then coil then small wick then coil to stop dry hits if that makes sense? or ss wick-coil-cotton wick-coil or reverse?
I know I make things complicated but I also like to be ahead of the game and push envelope. THanks Strapped

 

[-brandon-]

The outer coil would have little to no wick contact (based on wick material) which would produce a harsh hit, aka the dry hit. Not good.

 

[StrappedKaos]

Could you use this idea to wrap a large wick inside then coil then small wick then coil to stop dry hits if that makes sense?

Can I run two diff. coils from positive and neg. post with out any problems? I just dont want to do to much damage in process of trying new things. Trying to increase ohm while not micro wraping but have an idea on a better way to micro wrap too so either way it should be interesting.
Thanks for reply brandon

 

[dr g]

yes this would be possible but quite difficult to wrap.

 

[StrappedKaos]

Wow pain in the .... to wrap but got one to work, Ohms fluctuate so back to drawing board until I get a mech. mod.