My dream coil
- Thread starter Justadude
- Start date
- th_trl_thread_readers 0
- Status
I agree. That leaves nearly no room between the wires however because it's so tight it's virtually impossible to fix once you mess up. How do you keep the momentum going and go smooth the whole way while keeping it tight? This is especially difficult when wrapping around ribbon wire.
For my Clapton it's all about how you hold the wire. I pinch the wires tightly between my thumb and index finger.... Gives me a tight even wrap
Sent with one hand, the other is busy vaping.
Sent with one hand, the other is busy vaping.
After the first inch or so I do speed up quite a bit. The trick is in finding the right amount of pressure to apply. Once you get that down you can go a lot faster
seems like with the flat shape youd be better off wrapping the ribbon wire around the round wire.
Trolls lol
So I build the dual tiger coil but something went wrong and I ended up frying my plume. So now I'm out on a hunt for a new atty. What should I get? Tugboat? Another plume? What you guys recommend?
So I build the dual tiger coil but something went wrong and I ended up frying my plume. So now I'm out on a hunt for a new atty. What should I get? Tugboat? Another plume? What you guys recommend?
Sent with one hand, the other is busy vaping.
its quite a nice vape, getting lots of what i call fireworks being thrown from it or spits of juice/vape.
the only mistake i made was i only used 24g nichrome as main wire and the other two outer wires 32gA1 on 28gA1, the ohms are surprisinly really high, 0.7ohm so i had to put it on the sigelei at 8.5v= 100w
so next time maybe 22ga main and most probably A1 instead of nichrome.
the only mistake i made was i only used 24g nichrome as main wire and the other two outer wires 32gA1 on 28gA1, the ohms are surprisinly really high, 0.7ohm so i had to put it on the sigelei at 8.5v= 100w
so next time maybe 22ga main and most probably A1 instead of nichrome.
reverse double twisted?How about some anchor chain?
Sent with one hand, the other is busy vaping.
yeah I know, I don't have IPV at the moment, but that's the way to go, it takes forever to get heated up. I've even built on a lot higher gauge, 34 around 32 around 28 but still kind of a hassle.
At this point I'm all about stapled twisted tiger coil. That thing is amazing. And most important I think I got the claptoning method down when wrapping around a ribbon wire which is an absolute nightmare. Ordered more wire so the moment that comes in along with my new attys it's back to coil work
- Status
