My SX350 Pear Wood Mod

[something_vague]

So here are a couple bad pics of my latest creation. This is the 3rd mod I've built and may be my favorite one. It uses the SX350 chip set and has parallel 1200mah Lypo batteries installed. The 510 connection is one from Varitube and is as nice as Fatdaddy's IMO. I recessed the connector in the ebony top plate so all my atomizers will sit flush. The body is made of some pear wood with an inlaid ebony screen frame. The top and bottom plate is also ebony. I wanted to keep the build as clean as possible so I stayed with using only the gravity sensor in the chip to adjust wattage up and down, just didn't want to clutter the clean lines with two tact switches.

The dimensions are 3.5"Tall x 1 3/4" Wide x 1 1/4" Thick. I did my best to keep these dimensions as small as possible and still have reasonable battery life. Even at these dimensions everything was a really tight fit.

Any criticisms or comments are welcome.

 

[Visus]

It's gorgeous

Love the screen surround

really well done..

 

[DavidOH]

Well done that is really nice. But you must show us the inside as well. Us tinkering types like to see the workings as well.

 

[something_vague]

You guys and girls are going to hate me for the fact I didn't take any in progress shots and the mod is sealed up. If I need to I can take it apart to replace the batteries but it is no easy task. I have the ability as I used hide glue for gluing the bottom ebony plate on as I wanted something reversible for this exact purpose but def don't want to do it unless I have to.

 

[Rat2chat2]

I love to see ingenuity of others and I must say the inlaid ebony screen frame is an awful nice touch. Looks clean. Congrats to you. You should be very proud.

 

[holycrap]

very nice work keep up the good work. I like it