Nano Coil troubles

[Land0Calrissian]

I tried the nano again, and I'm running into some issues(?)

Its a real nice vape for like....3 pulls. Then I get the burnt taste. The cotton cloud under it seems to still be semi saturated but requires more juice?! I must be doing something wrong! Cause otherwise my initial reaction to this build is correct: "It uses up a crap-ton of juice."

I used 28 gauge, 11 wraps around a sewing needle. Read around .45 ohms.

Any knowledge appreciated.

 

[maxd]

cotton should NOT be packed in, just enough but not tight
as when it gets some liquid it will get bigger

 

[williebb123]

cotton is too big and or too much watts if your using a mech then cotton is your answer

 

[Bunnykiller]

what type of atty are you using?? sounds like a wicking issue...

 

[el Jexican]

Cotton is packed to tight. Should be fluffy, it allows for faster wicking to the coil.

 

[Land0Calrissian]

cotton is too big and or too much watts if your using a mech then cotton is your answer

ill try rewicking it a little bit 'fluffier' then

 

[Land0Calrissian]

what type of atty are you using?? sounds like a wicking issue...

I put that in my W4

 

[NaughtyGeek]

Cotton is packed to tight. Should be fluffy, it allows for faster wicking to the coil.

You sir are my hero of the day. I couldn't figure out why I wasn't getting the more intense flavor out of my Russian that everyone was going on about. Read this, rewicked and boo ya! Thanks ever so much.