• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Nebraska Vaping, Part 3

Status
Not open for further replies.

gotalotgoingon

Ultra Member
ECF Veteran
Verified Member
Mar 22, 2013
2,069
12,040
Nebraska/Dutch Harbor, AK
Going on day two of the Igo F. I moved the wicks tails out of the tank and wrapped them around the positive and negative posts on the deck. In doing so, the only way to get liquid to the wick is by the fill hole in the bottom of the tank or by dripping through the permanent drip tip. I am not in love with the fill hole on the bottom of the tank. Makes for some messy fills. Like I said earlier, there is no way of knowing when the tank is full unless liquid comes out of the fill hole or liquid starts coming out of the drip tip.

To be fair about my previous comment on the wicking and dry hits, I use I 35/65 PG/VG ratio so my liquid is on thick side.
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
Going on day two of the Igo F. I moved the wicks tails out of the tank and wrapped them around the positive and negative posts on the deck. In doing so, the only way to get liquid to the wick is by the fill hole in the bottom of the tank or by dripping through the permanent drip tip. I am not in love with the fill hole on the bottom of the tank. Makes for some messy fills. Like I said earlier, there is no way of knowing when the tank is full unless liquid comes out of the fill hole or liquid starts coming out of the drip tip.

To be fair about my previous comment on the wicking and dry hits, I use I 35/65 PG/VG ratio so my liquid is on thick side.

Hmmmm...so far I'm not loving your igo-f......love the L however.
Dunno....looking at the protank but not sure i would dig the cooler vape of a bottom burner. may try one anyway.
 

gotalotgoingon

Ultra Member
ECF Veteran
Verified Member
Mar 22, 2013
2,069
12,040
Nebraska/Dutch Harbor, AK
I have a couple of the Protanks as well. In my opinion, the Igo L provides a much warmer and flavorful vape then anything I have tried to date up to and including the Cisco HH 357 atty. In fact, I just took the F off my Provari and put my L back on. Was using the same juice, same ohm coil and same voltage with both the F and L and the vapor/flavor is more intense with the L by a long shot. Hawk, your money would be better spent elsewhere like on another L!
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
I have a couple of the Protanks as well. In my opinion, the Igo L provides a much warmer and flavorful vape then anything I have tried to date up to and including the Cisco HH 357 atty. In fact, I just took the F off my Provari and put my L back on. Was using the same juice, same ohm coil and same voltage with both the F and L and the vapor/flavor is more intense with the L by a long shot. Hawk, your money would be better spent elsewhere like on another L!

That's what I want to hear. I think you are probably right. I really am liking my 2 l's....might as well get another or 2.
Thanks Got.
 

gotalotgoingon

Ultra Member
ECF Veteran
Verified Member
Mar 22, 2013
2,069
12,040
Nebraska/Dutch Harbor, AK
What gauge wire and how many wraps do you use on your L? I just did a build on a new L and did 3 wraps of 30. It ohmed at 1.2 so I took a wrap off. I couldn't get a reading on my Provari after taking the wrap off but I would venture to guess it was .6-.8ohms. Then when going to a drag, it popped and a puff of hot air shot into my mouth. After taking the drip tip off, I did a burn while watching the coil and it was fine. Put the drip tip on and went for a vape and again, another shot of hot air and a pop like the coil caught fire. I repeated the process a couple times before setting the L aside. I am not sure if the L is not getting enough air since it only does this with the drip tip on while trying to pull a vape. It is the stock air hole and while on my other L's I modified the holes to 1/16th". I was going to put one of the modified tops on but I have the wick so wound up in them that it makes a mess taking the tops off and putting them back on. Not ready to deal with that mess right now.
 

Kent Brooks

Resting In Peace
ECF Veteran
Apr 24, 2013
17,678
91,969
48
Omaha, Nebraska, United States
www.nicoticket.com
Sup Kent?
Yeah....liking the cotton and not sure how easily it burns but I'm keeping good and wet.
Hmmmm.....looks like I have a site to check out?????

Definitely have to keep it on the wet side - once cotton gets fried, it's done done donesky. I'm not sure what site you are referring to, but I hear the eLiquid is fantastic. ;)
 

Kent Brooks

Resting In Peace
ECF Veteran
Apr 24, 2013
17,678
91,969
48
Omaha, Nebraska, United States
www.nicoticket.com
Busy, tired, then busy again lol.. How about yourself?


I been on ECF lockdown for a while so I been quiet. I got some vapemail!~ I am *loving* this new Sigelei #8. I topped it with my Octopus RDA, 2-3 wrapped 28 guage Kanthal @ .8ohms, thing hits like a truck. The mod showed up with 100% brass contacts, brass spring, and a brass firing button... I couldn't believe it. I need to post a pic. Nice setup, less than $25 shipped for the mod and the RDA. RAWR
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
What gauge wire and how many wraps do you use on your L? I just did a build on a new L and did 3 wraps of 30. It ohmed at 1.2 so I took a wrap off. I couldn't get a reading on my Provari after taking the wrap off but I would venture to guess it was .6-.8ohms. Then when going to a drag, it popped and a puff of hot air shot into my mouth. After taking the drip tip off, I did a burn while watching the coil and it was fine. Put the drip tip on and went for a vape and again, another shot of hot air and a pop like the coil caught fire. I repeated the process a couple times before setting the L aside. I am not sure if the L is not getting enough air since it only does this with the drip tip on while trying to pull a vape. It is the stock air hole and while on my other L's I modified the holes to 1/16th". I was going to put one of the modified tops on but I have the wick so wound up in them that it makes a mess taking the tops off and putting them back on. Not ready to deal with that mess right now.

The coil I have now is a 3/2 of 28ga. Kanthal. Was figuring it would come in around .8 but was 1.3???? I guess there's a lot of variance on the distance to the terminals and how far you wrap around the terminals. That's all I can figure.

Provari DID not like this coil. Fussed with it and fussed with it....screw it.....on the Bullet at 6 volts. The bullet doesn't care what you throw on her. I love my 2 bullets.
1.3 at 6volts. Nice warm vape. Just doing the math in my head....app. 20 watts???? Can that be right??? Yeah maybe. I've always felt that watts(and volts for that matter) aren't created equal. 10 watt set up on 1 device seems way different on another.

That pop with the tip on??? Air lock of some sort???
One thing I find with the L is that I need to rotate it so the coil is on the high side if I tilt it any. On the low side it gurgles, in between it kinda pops like you're describing...but not POP. And this is with the air hole at dead center coil. If you tilt any while hitting it and you haven't tried rotating it so the coil is in different positions...that might help. Air hole placement might make a difference. Or maybe it's that killer DIY you're putting in there. Scaring that coil:D

Hope you sort it out. Going to buy another L or 2 based on your experience with the F and the pro tank. Thanks for the input/advice.
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
Definitely have to keep it on the wet side - once cotton gets fried, it's done done donesky. I'm not sure what site you are referring to, but I hear the eLiquid is fantastic. ;)

Checked it. Nice site. No baccos:(....
I'm about due to try a sweet one again......maybe....lol. I always say that, then I vape sweet and ask myself what was I thinking?
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
I been on ECF lockdown for a while so I been quiet. I got some vapemail!~ I am *loving* this new Sigelei #8. I topped it with my Octopus RDA, 2-3 wrapped 28 guage Kanthal @ .8ohms, thing hits like a truck. The mod showed up with 100% brass contacts, brass spring, and a brass firing button... I couldn't believe it. I need to post a pic. Nice setup, less than $25 shipped for the mod and the RDA. RAWR

Post a pic of that #8 please. Like I need another mod. Hold it....yes....yes I do. I do need another mod...lol
 

gotalotgoingon

Ultra Member
ECF Veteran
Verified Member
Mar 22, 2013
2,069
12,040
Nebraska/Dutch Harbor, AK
To me it was a pressure build up in the L itself. I always turn the air hole and coil away from me when vaping until I start getting somewhat dry hits and then I rotate it towards me to finish up the juice. I have had this happen one other time and that was on the Cisco HH 357. It literally blew drip tip loose. I thought I had popped the coil in the atty but it was fine. It is overall weird. I will try putting another cap on with the modified air hole and see what that does. I am off to work now so I won't get a chance to play with it until at least tomorrow morning.
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
To me it was a pressure build up in the L itself. I always turn the air hole and coil away from me when vaping until I start getting somewhat dry hits and then I rotate it towards me to finish up the juice. I have had this happen one other time and that was on the Cisco HH 357. It literally blew drip tip loose. I thought I had popped the coil in the atty but it was fine. It is overall weird. I will try putting another cap on with the modified air hole and see what that does. I am off to work now so I won't get a chance to play with it until at least tomorrow morning.

Never heard of that before. Screw it. Just put in a mouth guard and don a pair of goggles and go for it:laugh:...
Seriously though, safety first. Hope you figure it out.
I'm sure you mentioned how many volts you're shoving into it. Does it do that at lower voltage?
One of our favorite questions in this forum when something isn't working right is.."are you holding your tongue right"? Are you?
Jake would tell you to stick your finger in it and wiggle it around a little bit. But he says that to a lot of things:laugh:
If you figure it out let us know.
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
Knuckleheads.......hope you roofed your cute little butts off today.
Wish I could have hung out, quaffed a few and told you where you were doing it wrong:D...
Cover it up if it ain't done.....don't want to join a wagon train to malcom(how the hell is that place spelled?????) to re-rock ceilings......
Haven't checked weather lately but last I heard tomorrow is dicey.

Miss you dummies:(....OL Hawk gets lonely without the pretty boys hanging out.

Oh sure...Kent has been here...and Gotalot....and I appreciate that, but get a load of the mugs on those 2.....

{{{see....this is where we see if they can hang with our sophomoric/drunken/juvenile behavior...}}}

:D...I'm bored and lonely.....and apologize to Kent and Gotalot....you're pretty boys too.....
Maybe not Pitt and Jake pretty...lol....
And there's a VERY good reason OL Hawk doesn't flash his pic.......unless you need a rodent deterant.....lol...

(I use to be a pretty boy.....kinda.....then I got married and "pitted"...and that's what I'm calling the plexi-glass curse from here on out....."pitted"...)
 

hawkizefan

ECF Guru
ECF Veteran
Dec 10, 2010
10,741
24,580
64
omaha
Now I'm ......!!!!
Y'all know how laid back and easy going OL Hawk is......but this is sacreligious.

Bored....lonely.....went out to check on Steve.

Me: hey buddy....how's it going?
Steve: whatchawant?goway.
Me: hey Steve....it's me...OL Hawk.....
Steve: goway....you no Misser Pitt.
Me: no....Steve....it's Hawk....calm down buddy.
Steve: you no Misser Pitt...goway!!!!

...????? Throwing bottles at the dude 2 weeks ago.....and I rock him to sleep.....a cheap bourbon, peed his pants sleep.....
And now it's all "Misser Pitt"......

You got some splainin to do Pitt.

I'm hurt.....deeply, deeply hurt. It was Steve and me forever.....
It was Steve and me(mostly me.....but Steve was in the corner looking at me with glazed over eyes) coming in here day after day yelling...
HELLO..HELLo..HELlo..HEllo..Hello..hello............
Nobody. Just me and Steve.
Now I get "you no Misser Pitt"????????
 
Status
Not open for further replies.

Users who are viewing this thread