Welcome to part 3! It didn't take us that long to get to this point, but here we are in all of our glory!!
- Status
Somebody christen this quickly with something inane and quite possibly something to tick off a mod
Here kittykittykitty.....
There is a new guy who posted in the Omaha paper article thread-a-ma-bob-thingy..say hi
Also make sure to vote 5 stars on the thread! This one is going down in the history books!
You and me both brother. Invite me once...thanks
Invite me back and...WTF...how drunk were you the first time...thanks again...
Alright, brother..you have a good one and enjoy your dinner and some R&R!
Alright y'all...my dumbass neighbor just got a hold of me...
I'm probably done for tonight...
Post at you from Boston tomorrow..
Peace out...
I'm probably done for tonight...
Post at you from Boston tomorrow..
Peace out...
I had to leave your posts alone in part 2..they were too appropriate!
Have a good flight and enjoy yourself as much as possible in Boston! I'll see you at the baggage claim!
It seemed everybody called it an early forum night..
Update on the LT. Could NOT get that damn PCB out of the tube. I don't know WTH to do with that. I am going to try something else after a bit though. Even tried just soldering in a tight space and at one point had the wires on there, tested it and it fired fine. Yay!, I thought..well I go to get it all put back together and the positive wire popped of off the board..back to the beginning now. I am close, but it would be a 2 minute job if I could just get the damn board out of there so I could have a bit of room and to not blindly solder away, lol.
Airports suck....traveling sucks....
But a high of 75 in Boston tomorrow...
Burn up maggots...lol....
I'm sure I'll pay for that when I get back sat. Nite. Hearing 100+ on Sunday.
Nothing under the rug keg....no need to look.....really...don't look.
Ok...ready to board....I'll check y'all when I hit Chicago....
But a high of 75 in Boston tomorrow...
Burn up maggots...lol....
I'm sure I'll pay for that when I get back sat. Nite. Hearing 100+ on Sunday.
Nothing under the rug keg....no need to look.....really...don't look.
Ok...ready to board....I'll check y'all when I hit Chicago....
That will be my last resort..gonna stop by the hardware store later, was thinking about grabbing some metal cutting rotary discs..Otherwise, I may try a socket extension and a hammer or chisel away at the solder on the sides of the PCB that are holding it to the tube itself.. Before all of that, I will give it a cleanup and try soldering once more without pulling everything apart.
- Status
