Need advice... ce2 ss barrel end stuck in delrin bottom cap...

[loft]

As the title says, I have a map tank and just went to switch my ce2 and alas... the ss barrel decided to detach and is lodged in my delrin cap. Luckily have a mini torpedo tank that fits the clear tube of the map tank, but I want my light weight delrin!

Any thoughts to remove the tube without destroying the delrin cap?

Ack!

Sent from my HTC Desire HD using Tapatalk

 

[PKZap27]

Find a socket that just fits inside the cap but will catch the steel piece and use that to push the piece of steel out of the delrin cap.

Put the delrin cap over a bigger socket and tap the smaller socket from the tank side with a small hammer to push the piece of steel through the delrin cap.

 

[loft]

Find a socket that just fits inside the cap but will catch the steel piece and use that to push the piece of steel out of the delrin cap.

Put the delrin cap over a bigger socket and tap the smaller socket from the other side with a small hammer to push the piece of steel through thye delrin cap.

Great idea!! I will have to do that tomorrow when its not so late. Thank you!!!!

Sent from my HTC Desire HD using Tapatalk

 

[gratefulbuddy]

If you have any of the tubes left from cutting the ce2s they work wonders for this.

 

[Tasteles]

You can also use a drip tip to drive it thru if your drip tip isn't wider than the tube. Drive it thru from the bottom, stand the drip tip on a table top and use a socket on the derlin cap.

 

[loft]

If you have any of the tubes left from cutting the ce2s they work wonders for this.

I do but that didn't seem to work. Didn't fit.

Sent from my HTC Desire HD using Tapatalk

 

[PKZap27]

A wooden dowel the right size should work also, you could sand it down if it too tight.

 

[Valsacar]

What I've done, when my barrel fell in, was take a cut one (always keep scraps, never know when they will be useful) and placed it on the other side (the concave part where you cut it goes in). Tap (from the end of the full barrel) with a spoon while holding the derlin tight. Keep going until it's the way you want it, remove pieces (took needle nose pliers for me) and all done.

 

[Tasteles]

I didn't think of this before but it would be the easiest way, just use the end that came out of the tube. Put it back in and drive it thru the derlin cap.

 

[loft]

Thanks for all the responses everyone. I got it out.