Need some help with the Vision Extreme 3.5ml

[Mikey3]

Hey all, Just got my Extreme in. Having some dry hit issues, Filled it below the cup, fluffed my wicks and the first few hits are good but after the 3rd or so i get the nasty dry burning taste. I have the worst luck!. Other then the dry hits though, this is an amazing design!!

 

[zer0ith]

What device are you using them on?

What maybe the case is the wicks are getting pinched by the cup seal, I would try lifting the cup seal up just a tad to see if that helps your wicking.

 

[Mikey3]

Tried lifting the cup a bit and it was pushed back down when the mouth piece went in. I also noticed that when putting the mouth piece back on, it creates a air bubble, not sure if that has anything to do with it

 

[arjay55]

I get the mouthpiece just started on the inner nipple thingy, then using my mouth I push it the rest of the way on at the same time taking a smooth soft drag on the PV (either with or without power - you choose). I find this stops the pressure build up in the tank and also stops flooding down the air tube. Works for me but ymmv

 

[badkolo]

you can also turn it upside down as you reinsert the mp. this will also alleviate pressure.

the pressure build up can be a pain but its a good thing, its one of the reasons the vision works so well, it almost feels like the juice is being pulled upwards becuase of the pressure as you vape.

 

[burns_erin]

On mine I found if I didn't get the wick slots lined up quite right it would have this problem as well. Maybe try using tweezers to try to twist the plug just a bit.

 

[badkolo]

yes the slits on the plug need to be aligned properly like you said for it to work properly, you can also use this to clean them and your fluxos ce2 deluxe
Pipe Cleaners

 

[robl45]

you can also turn it upside down as you reinsert the mp. this will also alleviate pressure.

the pressure build up can be a pain but its a good thing, its one of the reasons the vision works so well, it almost feels like the juice is being pulled upwards becuase of the pressure as you vape.

i tried this and juice leaked out the top, clearly i did it wrong

 

[badkolo]

clearly, you seem to be a clumsy one rob lololol.

 

[Mikey3]

Thanks all for the Info, I know the plug was lined up so that was not the issue, I am going to try some other things when i get home today.

 

[Modrod.]

yes the slits on the plug need to be aligned properly like you said for it to work properly, you can also use this to clean them and your fluxos ce2 deluxe
Pipe Cleaners

Pipe cleaners. I keep forgetting to get some.