New ecig arrived!!! cartomizer + tank system

[thxhouse]

Hey guys, i bought a new ecig after my ego kits' atty died on me, i was too lazy to research further so went back to cigs :/

anyway I ordered some cool parts last week and back to vaping again.

2 ego T batteries.
1 battery/pastru.
3 ego-t atomizers
5 boge cartomizers
5 tanks
around 40ml of juice.

i havent tested out the tank system yet its still on its way but the cartomizers are great. Great throat hit and best of all, it lasts me hours

The passtru is amazing. I dont have to disassemble my whole ego now just because i came from outside (i had the 510 passtru only thing).

My only complaint is that im having trouble filling these cartomizers. I used a suggested "condom" method, after looking it up on youtube and it looked great there, but when i tried, it was really messy. liquid ran up the sides of the condom and out of the condom eventually. any ideas?

Also i have a bad cold at the moment so cant really taste anything, is there any way to tell that my cartomizer is running low? (btw menthol is helping by nasal congestion :d)

 

[Rosa]

Are they just the standard 510 boge cartomizers with the soft end cap?

If so, you can just take the end cap off (needle nose tweezer or bent paper clip) and drip juice into the filler but not down the middle hole while turning the carto so you get it down all the sides.

 

[Rosa]

.... or maybe you didn't take the little plug out of the hole at the battery end?

 

[thxhouse]

standard boge 510 cartomizers with white soft end cap. Thanks for the dripping info.

I did take that silicone plug off. but i think the problem is the hole at the bottom of the 510 cartomizer is kind of too small. Did not have a perfect seal. I am gonna try pipetting it from the battery hole when i get to work tomorrow

 

[tigerlily]

I don't like the condom method either. IMO it's just unnecessarily messy. Try the method Rosa mentioned. It works much better. Just be sure to put in a few drops, let it soak it, then add a few more. Keep doing that until the filler remains wet-looking.

If you're having trouble tasting the vapor because of your cold, you can just remove the white plug and look at the filler material. If it looks dry, go ahead and add some more juice.