New RM2 not squonking right

[oplholik]

On my others I just squeeze the bottle and hold for a 3 or 4 count. This one, I have to pump the bottle a few time,s then the juice will start to come up. The end of the tube is clear of the bottom of the bottle, I ran water thru the top of the connector, and thru the tube via a needle and syringe, and that is clear. Would this have to do with the bottle not seating correctly against the o-ring in the cap?

 

[nerak]

On my others I just squeeze the bottle and hold for a 3 or 4 count. This one, I have to pump the bottle a few time,s then the juice will start to come up. The end of the tube is clear of the bottom of the bottle, I ran water thru the top of the connector, and thru the tube via a needle and syringe, and that is clear. Would this have to do with the bottle not seating correctly against the o-ring in the cap?

It could be that or the tightness of the cap. Try it a little tighter and see if that helps.

 

[Matthee]

Probably, try an o-ring from one of your other Reos maybe. And a different bottle.

 

[johni]

Is the tube getting suctioned to the bottle? Did you cut a V in it?

 

[oplholik]

Is the tube getting suctioned to the bottle? Did you cut a V in it?

I didn't cut a v in it, but it is about 1/8" off the bottom.

 

[oplholik]

Ok, just needed to tighten it down harder, o-ring wasn't fully seated I guess.

 

[rabernet]

Is the o-ring buckling from over tightening? That happened to me before.

Sent from my Samsung Note II using Tapatalk 2

 

[Krazirob]

its that damn cap....ive had so many problems with this.....if you look at where the rubber gasket is in the cap its does not seat well sometimes because its sitting on the threads of the cap......the thread go all the way up to the curved part of the cap where the tube goes.....just gotta tighten it just right.....not too tight and obviously not to loose.

 

[johni]

Glad you got it sorted out. Vape on.

 

[yaypudding]

speaking of which, does anyone know the size of the o-ring that goes in the cap?

 

[custom-classic]

1.5mm X 10mm. #7 o-ring.

 

[oplholik]

For all things dimensional

http://www.e-cigarette-forum.com/forum/reos-mods/161169-reo-measurements-parts-terminology.html