My New Vision Spinner just arrived today, charged it, put on the atty, pressed the button, nothing... No light, no Vaper.
What did I do wrong, or could it be bad...
What did I do wrong, or could it be bad...
- Status
It is a GotVapes VisionSpinner 1100mah and a GotVapes MiniViVi Nova510 2.4ohm.
There does not appear to be an on/off. It has multiple settings 3.3-4.8. Plugged into the Charger it shows a green light after a couple of hours charging.
Charging my new GotVapes VisionSpinner 650mah now. The 1100mah one is not working.....
There does not appear to be an on/off. It has multiple settings 3.3-4.8. Plugged into the Charger it shows a green light after a couple of hours charging.
Charging my new GotVapes VisionSpinner 650mah now. The 1100mah one is not working.....
Are the connections clean. Are the center posts on the PV's perhaps pushed down and not making contact. Way to tell is to mark the center post on the battery with a felt tip marker good and put on the atty right away. If when you remove the atty there is no spot that has been wiped clean then the center post on the battery(s) is too low and you will need to either pull it up or pull the center post on the atty up. I would do it on the atty since they cost less if you mess up. Also since neither works it may be the atty. Also you have a 2.4 ohm atty and you may need to crank up the volts some to get your 4-8 watts out.
Let us know what you find.
Let us know what you find.
Even though there doesn't appear to be an on/off button, you may need to push the one button that's on it five times fast to turn it on. Before you toss it back in your pocket/purse/etc , hit the button five times fast again to turn it off so it won't fire up when you don't want it to.
Just took my first pull... This thing is so awesome over the skinny little thing I have been using... Is therea Spinner forum so I can read more on this thing...
I'm looking at the main differences in voltage, i.e. battery life, amount of liquid used, etc. My other nagging question is the nicotine. If i hold the vapor in longer instead of just blowing it out, will I get more nicotine?
Thank you all very much.
I'm looking at the main differences in voltage, i.e. battery life, amount of liquid used, etc. My other nagging question is the nicotine. If i hold the vapor in longer instead of just blowing it out, will I get more nicotine?
Thank you all very much.
Hehe, you just gotta press it 5 times and remember that the higher you put the voltage the faster your battery will run out.
Most of the nic you get from vaping you get from your mucous membranes (mouth and nose), not your lungs. The vapor molecules are much bigger than smoke molecules and aren't absorbed readily in your lungs. If you want more nic, take long slow pulls, hold in in your mouth briefly before inhaling, and then exhale through the mouth and nose..
I was waiting for madvapes to restock these but ill just head over to gotvapes. Nicer and shorter than normal ego ecigs(hoping they have a blue left)
I just got a chrome 1300 and it rocks - except it is hard to read the voltages. If that matters get a black one, the look much easier to read. I should have.
Ha My friend just went threw this with a VeriTube X HE called me said it did not work I told him click it fast it should come on. He says I am and its not working. He called emailed the vendor ended up sending it back they turned it around told him it works fine. He was up set to say the least!
He drove from St Louis to California to show me his non working mod. He had print out of the emails he wrote down everything word that was said between them.
He arrives to CA I ask him to turn it on he pulls it out and goes clikc........ click.......click......click I ask him to see it click,click,click,click.click Ta Da it comes on! He wasent clicking it fast enough HE Looked embarrassed disgusted and mad all at the same time with out saying a word he garbed his mod and drove back to ST Louis!!!! Two weeks later he called and said thanks for the help and he likes it a lot.
I love this guy a very good friend but a bit high strung!!!!!!!!
He drove from St Louis to California to show me his non working mod. He had print out of the emails he wrote down everything word that was said between them.
He arrives to CA I ask him to turn it on he pulls it out and goes clikc........ click.......click......click I ask him to see it click,click,click,click.click Ta Da it comes on! He wasent clicking it fast enough
HE Looked embarrassed disgusted and mad all at the same time with out saying a word he garbed his mod and drove back to ST Louis!!!! Two weeks later he called and said thanks for the help and he likes it a lot. I love this guy a very good friend but a bit high strung!!!!!!!!
- Status
Similar threads
