*** New Stock Updates ***

Status
Not open for further replies.

kaeo773

Unregistered Supplier
ECF Veteran
Mar 10, 2009
926
4
Chicago USA
www.modernvapor.com
Tony, are the Smart PCCs for Sideshos only or do they work for 902s?

Right now they are only for the Sidesho, I didn't order that many because they are not done with the taller ones. You can use the smart ones for for only 902 autos only. They are making the manual slot 902 smart PCC's now, so the 902 manual will work. It was not worth it to buy the 902 ones without a manual slot.

The Sidesho Smart PCC does not have a manual slot cut into it like the ones now. It works great at charging the manual battery, and you can fit both manuals in the case, and the lid closes. You do need to use the newer manual batteries we have that has that smaller profile button, the button also has bigger flange, so they don't come off easy.


The site will be messy for a bit till I take all new photos & work on the redesign.
 
Last edited:

kaeo773

Unregistered Supplier
ECF Veteran
Mar 10, 2009
926
4
Chicago USA
www.modernvapor.com

scheherezade

Super Member
ECF Veteran
Verified Member
Feb 10, 2010
577
2
VA Beach
Hey Tony, haven't been able to get on much the last few days, so I'm going back and reading to catch up a bit before I get my order in. Lots of new goodies to try. Are the low ohm attys going up soon too, or are they still in testing stage. Just trying to figure out what I'm ordering now and what I'm ordering later. Geez, I'm taking notes on what came in for the sidesho and what came in for the 902. Too many things on my wish list. LOL :)

Just found my answer, sorry, new attys are still being tested. Ok, now back to the shopping list!
 
Last edited:

keveck

Ultra Member
ECF Veteran
Mar 11, 2010
1,291
2
aaa
New PCC is sweet! That LCD is nice! And it changes from blue backlit to red backlit when it's charging.

That little chrome bar below the LCD in the picture is actually a multi-purpose button. Press the left side of it for the flashlight(hold for a few seconds and it will stay on), press the right side for the battery level on the LCD (Hold to charge battery in slot), and the LCD turns red while charging. I'm not sure how to tell when it's fully charged yet though.

The new PCC is ever so slightly larger than the old PCC. About 1.5mm taller and 0.5mm wider.
PCC can hold 2 manual batteries now, and the pack will shut! Can't wait for the new short batteries so I can put I fully assembled sidesho in there though!

And LR atty testing is happening now. So far, so good. I'll keep you posted!

EDIT: LR atty is performing like a champ! It feels like I'm getting more nicotine than when using a normal atty. Also vapor production is about 1.5x. It's very similar to vaping on the 5v usb passthru. I had to stop testing because I got a nicotine headache so quickly!

Will try to attach it to the 5v usb passthru soon. That's probably not recommended, but I'm gonna run this thing through the gamut! If it makes it through ok, you've got a winner Tony!

The only difference I can tell in appearance is that the wick is slightly wider than the normal atty.

EDIT#2:LR atty doesn't play nice with the usb passthru. It works fine, but tastes funny and burnt. It actually tastes better with the normal battery!
And the atty is starting to get broken in. Vapor production is getting even better!
If you flood it though, it almost has to be blown out. You can't burn through it as well as a normal atty. Seems like it takes less to flood it too.
 
Last edited:

grndzero

Senior Member
ECF Veteran
Feb 8, 2010
110
0
Tucson, AZ
EDIT#2:LR atty doesn't play nice with the usb passthru. It works fine, but tastes funny and burnt. It actually tastes better with the normal battery!
And the atty is starting to get broken in. Vapor production is getting even better!
If you flood it though, it almost has to be blown out. You can't burn through it as well as a normal atty. Seems like it takes less to flood it too.

LR attys aren't designed to work well with USB passthru's, and shouldn't be used on them. The LR is designed to give the experience of vaping on USB (higher voltage) with a (lower voltage) battery. A LR on a USB passthru would be simulating vaping at 6-7 volts instead of 5 volts like USB. Since LR atty's aren't designed to run on USB (5V) they will heat up faster, give a burnt taste, and probably burn out quicker.
 

kaeo773

Unregistered Supplier
ECF Veteran
Mar 10, 2009
926
4
Chicago USA
www.modernvapor.com
Any update on when we'll be able to get one of the Taller PCC's and the shorter batteries?

Just working out the new mold, I am paying to have the tall PCC designed to work best with my needs. The sample they sent me was not what wanted, and would not do the job that I needed. So, I could get the one they designed right now, but I will solve everybody's needs with the one I am paying for to get made.

The small batteries are on the way, they have been ordered, as well as the low ohm attys for both models.

MidniteVulture,

I also redesign the insert for the new metal case to fit the manual battery. The first set was a rush job from another factory that didn't have my parts to make an accurate insert.





Also will have 4 colors in the samrt PCC for both models. We designed the 902 manuals to have a lower profile button, so they will work in the smartt PCC's.

 

pdssoft

Senior Member
ECF Veteran
Feb 18, 2010
129
9
Michigan, USA
Bump!

Any news on updates? I want to place an order (just because ;) ) but I pretty much already have everything. Even the new PCC (Nice BTW).

I guess I could get a pass-thru but... I have concerns about being "tethered" to my PC. :vapor:

Also, yes another question, I've been thinking about the 902 (just cause the carts look huge), can the 902 and Sidesho batteries be charged in the same charger? Is the battery polarity the same?
 

grndzero

Senior Member
ECF Veteran
Feb 8, 2010
110
0
Tucson, AZ
I guess I could get a pass-thru but... I have concerns about being "tethered" to my PC.

Is that's all you're worried about then look at portable battery packs with USB connections. There are a few out there. This is one. Welcome to Usb.brando.com You can also get a DC to USB adapter for the car.
 
Status
Not open for further replies.

Users who are viewing this thread