New tanks and coils

Status
Not open for further replies.

Susan~S

ECF Guru
ECF Veteran
Verified Member
Mar 12, 2014
16,937
11,694
68
Mpls/St.Paul, MN
Did you prime your new coils?

Priming a Coil

All cotton coils have to be primed well with juice. If they are not primed well the cotton will burn. Once the cotton is burned the burned taste doesn't go away.

To prime the coil, drop 5-8 drops of juice right inside the coil (sometimes less/more depending on the size of the coil head), another drop of juice in all the holes on the side of the coil. Put the coil in the base.
  • If Bottom Filling - Fill the tank and then screw the base back onto the tank.
  • If Top Filling (some tanks are top filled) - Screw the tank on the base and then top fill it.
Once you put the tank on the battery give it several unpowered primer puffs. This will make sure the wick is fully saturated.

Rule of Thumb

The rule of thumb for EVERY vape device you'll ever own is the same (when running in power or wattage/voltage mode). Turn your voltage/wattage down, take a few hits, bump it up, couple more hits. Repeat until you find your "sweet spot". If it starts to taste funny, gets too hot or tastes burnt, back it down. Different flavors will have different sweet spots so you just have to experiment.
 
Status
Not open for further replies.

Users who are viewing this thread