New to ECF, having filling problems with my Fogger v4.2

[zombietaz]

Hi guys!

I am new to ECF, have been lurking occasionally and vaping in the meantime.
I recently bought myself a Fogger v4.2 from froginfog. Right off the bat, the glass tank was smashed, so I ordered a metal replacement.
I seem to have an issue every time I go to fill my tank. EVERY time, no matter what I do, a ton of juice starts leaking out through the drip tip. I have adjusted my wicks, so they sit a little in the channels, nothing happens. I have tried holding my finger over the drip tip and closing the airflow whilst slowly putting juice in and holding the tank at an angle... still nothing.
I even replaced the o-ring on the upper part of the chimney, to no avail.
I am using dual 28g micro coils wrapped on a 5/64 bit, which reads out as 1ohm. I am using cotton to wick.
If anyone has any idea on where the hell I am going wrong, please let me know!! If not, I am at my wits end, and will sell the damn thing. Its been a PITA since day one, and if I can actually get it to perform the way everyone else seems to be able to, it will be a miracle!

Thanks in advance guys!

 

[AmandaD]

Mine leaks out of the drip tip too when I'm filling it. I put in a piece of rolled up paper towel in there now - problem solved!

 

[zombietaz]

Mine leaks out of the drip tip too when I'm filling it. I put in a piece of rolled up paper towel in there now - problem solved!

thats a good idea, but I feel like it is a massive waste of juice!

 

[AmandaD]

thats a good idea, but I feel like it is a massive waste of juice!

It's only a little bit if you take out the drip tip and stuff the hole. The paper towel stops most of it coming out.

 

[zombietaz]

Well it beats anything else I got going. Will give it a shot!

Sent from my HTC One using Tapatalk