So I just ordered and received my first mech mod today, the Smoktech Magneto 2. However, I'm a little bit hesitant to start using it as I'm not too educated on mech mods and battery safety. Can anyone give me advice on how to properly use a mech mod, or even how you use your smoktech magneto 2 if you own one? On hand, I currently have (besides the mod) an 18650VTC4 2100mAh 3.7V 30 amp IMR battery, an efest 18350 700mAh 3.7V (not sure on amps), as well as a double vision rda with a 0.21ohm dual Ni200 coil build. Should I look at getting a different build on my rda? I'm just looking for advice on how to safely use my mod, perhaps a link to some sort of tutorial/guide could help too. Thank you in advance!
- Status
The Sony VTC4 is a fine choice, the Efest is not. Ni200 is for temperature control use only, do not use it.
The Sony has a 23 amp CDR. Have a good read, if you have any further questions feel free to ask.
(8) A Beginner's Guide to Your First Mechanical Mod | E-Cigarette Forum
(16) Explain it for the dumb noob: Ohm's Law calculations for a Mechanical Mod. | E-Cigarette Forum
https://www.e-cigarette-forum.com/f...s-law-calculations-for-a-mechanical-mod.6618/
(9) Battery Basics for Mods; the Ultimate Battery Guide | E-Cigarette Forum
Read all the blogs, Mooch is the man
Mooch
The Sony has a 23 amp CDR. Have a good read, if you have any further questions feel free to ask.
(8) A Beginner's Guide to Your First Mechanical Mod | E-Cigarette Forum
(16) Explain it for the dumb noob: Ohm's Law calculations for a Mechanical Mod. | E-Cigarette Forum
https://www.e-cigarette-forum.com/f...s-law-calculations-for-a-mechanical-mod.6618/
(9) Battery Basics for Mods; the Ultimate Battery Guide | E-Cigarette Forum
Read all the blogs, Mooch is the man
Mooch
- Status
Similar threads
