Learned something new today. The quickest way to exit the menu, is to hold the power button down and 2-3 sec you are back to main screen.
NEW YIHI SX MINI ML CLASS!
- Thread starter smokyribs
- Start date
- th_trl_thread_readers 0
- Status
Where did you here this info?
How would it be "SX Pure" then?hopefully, a RBA will be included
I read their FB page everyday and I guess I missed that post. I'll be looking forward to the tank coming out.
I had been using this mod on 60-75w with my regular low resistance builds and it was nice but not overly impressive and absolutely killed my batteries.
Last night I built a .47 single coil in my Smok RBA and started messing with it at 30-40w and man does it shine. The modulation in powerful+ is really nice heats up the coil fast and then backs off right where you want it.
Last night I built a .47 single coil in my Smok RBA and started messing with it at 30-40w and man does it shine. The modulation in powerful+ is really nice heats up the coil fast and then backs off right where you want it.
That mate is a top noth tip! Cheers I had been going to exit or waiting lol Doh!
No problem, better to stay on their good side and do as they ask.
I need to pick up some Nife too
Resitherm for my Dicodes box that has reached international shipping depot
How much would you prepay for it knowing absolutely nothing about it?Oooo a very special atomizer .... I'm sold
Id go as high as $50
How much would you prepay for it knowing absolutely nothing about it?
Id go as high as $50
lol if its only you and I bidding my inside information on this trade says I must hit $50.01
Makes me wonder why they'd have a separate mode? If it's just another run of the mill atty what would be the need?
The TCR value (0.00138) for SS430 is wrong, or Yihi need to fix their 2.202 firmware.
It torches the wick even when temp is set to 212f.
It torches the wick even when temp is set to 212f.
Last edited:
I doubt it's wrong as there would be widespread reports if so, It may be wrong for your particular wire or there may be something out of calibration. I don't have any 430 to test but Steam Engine list it at .001380 as well as I've seen others in similar range. I'd suggest you try the cotton burn test with a single spaced coil "untwisted", pulsing first to get out all the hotspots and hot leges, then making sure to let sit for a bit and lock the resistance at room temp and setting the Compensate temp to room temperature then try the test again.
Last edited:
After torching the wire for a bit the temp control protection is working correctly up to 400f.
Looks like ill have to rebuild two tanks, since i couldnt figure out why i was getting dry hits even at 285F. Need to torch SS wire for a lot longer before i start building coils out of it.
Looks like ill have to rebuild two tanks, since i couldnt figure out why i was getting dry hits even at 285F. Need to torch SS wire for a lot longer before i start building coils out of it.
- Status
Similar threads
- Locked
