New Youde RTA the Bellus

[ccwaters]

been using it quite a bit since It arrived, most of the juice I make is 30/70vg, but I've tried it with 98VG, and some 40/60 commercial juice, still haven't had any leaks, or wicking issues, It isn't the best RTA I've used flavor wise, but it is right up with them, still my favorite dual coil tank. Quick simple access to the build deck is a big part of why I like it.

 

[MXMbrewing]

Just got mine in from efuntop. Noticed that the single coil adapter is some form of silicone and plastic, thought it was supposed to be silicone and metal. anyone else get one with plastic or ptfe or whatever that material is ?

 

[MXMbrewing]

never mind, found the answer in the Mike Vapes vid.

 

[ThunderDan]

never mind, found the answer in the Mike Vapes vid.

What was it? I saw it in an unboxing and assumed it was ceramic, but didn't see mike vapes comment on it.

 

[csheroe]

Stopped leaking after taking the base out and swabbing the chimney while holding it upside down on the first fill. Vapes great now on a .54 ohm 2.5mm 26 gauge kanthal build at 30 watts. I guess patience is the key lol.

 

[MXMbrewing]

well it feels ceramic.

 

[MXMbrewing]

Getting good flavor, running dual 8 wrap 26 gauge titanium Gr.1 at .15 ohms. 445 degrees at 40 watts. No leakage so far. Topped the tank off after a few vapes.

 

[Two_Bears]

Getting good flavor, running dual 8 wrap 26 gauge titanium Gr.1 at .15 ohms. 445 degrees at 40 watts. No leakage so far. Topped the tank off after a few vapes.

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

 

[Two_Bears]

Getting good flavor, running dual 8 wrap 26 gauge titanium Gr.1 at .15 ohms. 445 degrees at 40 watts. No leakage so far. Topped the tank off after a few vapes.

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

 

[Two_Bears]

Getting good flavor, running dual 8 wrap 26 gauge titanium Gr.1 at .15 ohms. 445 degrees at 40 watts. No leakage so far. Topped the tank off after a few vapes.

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

 

[Two_Bears]

Darn I wish the place I live would fix the darn WiFi.

It goes from 5 bars to nobe in the next second and gives the impression the message did not go through

Sorry for the multiple posts guys.

 

[Croak]

It's ok.

It's ok.

It's ok.

 

[roxynoodle]

Mine came a day early. Just finished my first build and it gets a big Flavor is fantastic, filling is easy and wicking was straight forward. The only con is that there isn't a whole lot of room on that deck.

Build: 2mm dual Claptons, 26/32, 5 wraps, 0.34 ohm.

 

[shatteredsoul76]

I didnt have the best of luck with my first build and the wicking and got a burnt hit as well as some leaking on the refill which was not enough cotton. After some of the post in this thread I tried it again by placing the coil higher up for better airflow and tweaking the wick and its been much better. When this wick is done Im going to rebuild it with dual coils and move them even higher for more airflow.

 

[TheWestPole]

Mine was delivered today from Efun.top. Did a 0 gauge, 0 mm, 0 wrap build, 0 clouds, 0 flavor. Just got home.

 

[Croak]

Mine was delivered today from Efun.top. Did a 0 gauge, 0 mm, 0 wrap build, 0 clouds, 0 flavor. Just got home.

Amazing battery life though.

 

[ashtrayogdc]

Mine was delivered today from Efun.top. Did a 0 gauge, 0 mm, 0 wrap build, 0 clouds, 0 flavor. Just got home.

Amazing battery life though.

Oh u guise...

 

[digital_karma]

when in single coil setup, how do you compare it with subtank mini in terms of airflow and flavor? i'm more into MTL guy. thanks!

 

[zoiDman]

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

I can't use the darn thing.

I got my Bellus today. First there is no knurling on the top to make it possible for me to remove the top. If I fill the Bellus and tighten the top down I can't get it open because there is no knurling to get hold of the top. If I don't tighten it down fully tight the tank leaks like crazy.

It MUST have a good vacuum to prevent leaking.

I love the Velocity two post design.

The plug to block one side of the build only fits on one side. The side with the divet in the deck.

The airflow is amazing anything from a
MTL to full lung hit. With all the airflow you should be able to vape this at 60+watts with no issues.

The silicone plug works well. The bottom part is clear silicone and the top us hard plastic or ceramic.

The flavor was better than the Kanger Subtank and the Taifun GT 2;

However the flavor was no match for my Goblin Mini or my Kayfun Nano.

I showed the Bellus to my next door Neighbor Jon S. And he fell in love with it so I have already tested the Bellus and sold it.

I had such high hopes for this tank but oh well. That's the way the cookie crumbles. As least I quickly found it a new home.

This Dupodrens contracture in my left hand is a real pain some times.

If you have two good strong hands check the Bellus out. Otherwise be prepared to have the Bellus leak like a sieve or fill the tank from the bottom.

I wish it had a top fill similar to the Lemo 2, or the tank that has one setting for vaping and another for vaping

Is there an, Is there an, Is there an Echo in Here?

LOL

 

[roxynoodle]

Is there an, Is there an, Is there an Echo in Here?

LOL

Either he's very angry or his internet stuttered.