The kit comes with 2 atomizers, so you don't need to buy any more of them. Just be aware of what they are for and get 510 sized drip tips. Drip tips are only $2-3. You need at least one, or you'll waste more cartomizers than the drip tip costs.
I can't even remember the names of them. I think one is made by Ruyan and called the e-cigar. If you google the term e-cigar, you'll probably come up with it. There really aren't that many. The thing is, once people start with an e-cig, they quickly lose their interest in having it look like something they used to smoke. So there is no incentive for manufacturers to spend any money creating a good performing clone of a cigar or pipe. Only newbies are really interested in them and they quickly move on. The slight exception is for the pipe category, but even then, good ones are very limited production and very expensive.
I tracked it anxiously and it arrived! I'm a bit overwhelmed. I seem to have two batteries, a wall charger, and a PV case end for the battery. Check. I have the switch, connected to the battery. Check. Now the confusion. I got two atomizers, 5 atomizer cartridges, 5 cartomizers, a bottle of flavor ("Black-n-Mild" - I like!), and two drip tips. Now I am experimenting with how to combine everything. I tried putting an atomizer on, popping off the empty (totally empy, no cotton or anything) cartirdige, opening a new cartridge (touched it an confirmed the cotton was wet), screwing it onto the atomizer and taking a puff. I got a nice puff but a distinct burning taste and it hurt my lungs a little.
Pretty close. What you want to do first is blow into the mouth end of the cartomizer to get rid of any primer or liquid that might be left in there from the factory. Then, attach it to your battery and drop about 3 drops in and let it soak a few minutes. Now it is "primed". Then, drip 3 more drops in there and vape. You can drip straight through your drip tip or do it with the drip tip off if you want to see exactly where the drops are going. Try to hit the center "bridge" and not let it run down the sides. If you flood it and it starts to leak, no worries. Just take it off and blow through the mouth end into a paper towel and start over.Next thing I tried: I dropped a few drops of the 30ml flavor jioce that came with it (Black-n-Mild) right onto the atomizer, then pput the drip tip into the atomizer and took a few puffs. Nice flavor, got a few solid hits. I'm hoping that was the correct way to test a flavor referred to in the forum thread.
REmove any rubber disc or washer. Tilt the carto so that the drops are running down the edge into the filler. Avoid getting juice in the center tube or hole. Drip 3 to 5 drops at a time and let it soak in for 15-30 seconds, then do it again. The regular sized carto should hold 50-55 drops. The XL's should hole about 70-80 drops. When it is thoroughly soaked, it will look slushy on top. Before you vape it, blow any excess out from the mouthpiece end into a paper towel (paper towels are a vapers best friend). Put the drip tip in the end. Don't replace the washer or rubber endcap that came on the carto.Next on to the cartomizers, 1.7ohm "resurrectors," 5 of them. I'm *assuming* these are blank. So I watched a youtube vid and it said you pop off the back (the side going into your mouth) with a little pin to expose the cottton, then squirts around the edges with a syringe. I have no syringe. I just gently dapped around the edges, but within seconds liquid was dripping out the other end; I think I got some in the hole in the middle and wasn't supposed to. Then I thought to myself, is this where I am supposed to use the drip end? Plug it in in place of the rubber disk with the hole in it, and drip flavor throught it? And, am I then supposed to put the rubber disc back, or leave the drip tip in as a mouth piece? And, when filling the cartomizer, am I to disconnect it from the switch or leave it connected to it?
Thanks all! So far everything that came with the epower kit from CCV seems to be what I'm looking for now, I just need to figure out how to correctly use it and refill it and not burn anything. Can I refill the cartridges too? Looks easy enough to just drip my flavor onto the cotton.
TIA for the help and advice!