Hi there, I recently ordered a KR808D-1 from vaporkings.com. I ordered the starter kit because I've never bought an E-Cig before and wanted to just try it out. The kit was supposed to include 2 pre-filled cartomizers but I didn't know that vaporkings won't ship pre-filled cartomizers or e-liquid to Canada, so they sent two blanks. So I then ordered e-liquid from a Canadian site and just got it in today. I searched the web and found out how to fill the cartomizer. So I pulled out the mouth piece and the rubber gasket and put in 10 drops, put it back together, set it down on the battery part to let the liquid soak in for 15 minutes. I screwed it onto my E-Cig and tried to take a puff. Nothing. I kept taking 4 second long puffs for a full minute and I got absolutly no vapor. So I added a few more drops and waited again. Same process has left me with no vapor. I'm positive that I've done everything right but I'm getting nowhere at all. Can anybody tell me what I can do to get the bloody thing to work?
Newbie E-Cig user can't get E-Cig to work :(
- Thread starter hockey_playa131
- Start date
- th_trl_thread_readers 0
- Status
You may have done this, but is the battery charged? Does the light come on when you press the button (if its manual, if auto than when you pull air through it)? If not, then it needs to be charged. If it is coming on and you are not getting any sizzling sound from the cartomizer, then it could be a bad carto. The carto should get a bit warm too. Sometimes batts are empty or very low upon delivery and they need a full charging. If neither of these suggestions take care of it, contact the VK and see what they have to say...it might need replacing. It happens. Good luck!
Probably not enough liquid in it to vaporize would be the 2nd thing I'd check.
A new blank cartomizer typically holds about 30 drops and you said you put in 10?
A new blank cartomizer typically holds about 30 drops and you said you put in 10?
- Status
