RDA Nickel coil build on a velocity rda

[OhmzRaw]

I used 28g Ni for mine but it fit in the Velocity. 14 wraps per coil on a 3.5mm machine screw. Ohm reader says .08Ω, my IPV3 Li says .1Ω
View attachment 482291

I did 24G Ni 15 wraps 3mm ID reads at 0.09ohm

 

[OhmzRaw]

I used 28g Ni for mine but it fit in the Velocity. 14 wraps per coil on a 3.5mm machine screw. Ohm reader says .08Ω, my IPV3 Li says .1Ω
View attachment 482291

Are you sure about the figures? Check it out on steam engine. I punched in 28G ni single coil target resistance at 0.08 3.5mm ID.... number wraps says 4.8...