Nimbus Clone won't fire.

[ItsAlex]

I just got the chimbus and took off the pre-made set up and built my own dual coil set up. Nothing. doesn't fire. Take off each coil and fire individually and they all glow red, but when I put them together no luck. I'm using 3/4 wrap 30GA on a k100, 18500 IMR batt, and I'm at .5 ohms.

Chimbus - Imgur picture of build.

 

[ColinD]

Possibly a centre pin issue not making proper contact below. Try taking out the battery first -screw the clone into the unit flush and then reassemble. The K100 has a floating pin I believe.

I just got the chimbus and took off the pre-made set up and built my own dual coil set up. Nothing. doesn't fire. Take off each coil and fire individually and they all glow red, but when I put them together no luck. I'm using 3/4 wrap 30GA on a k100, 18500 IMR batt, and I'm at .5 ohms.

Chimbus - Imgur picture of build.