Not sure how to (at what resistance) build these Kayfun clones

[BicStic]

Hi,
I have a couple of Kafyun clones and I have been building them mostly at 1.8- 2.2 ohms and getting great results with my Vamo v5 running anywhere from 12-15 watts. I just recieved a MPV that maxes out at 11 watts. Last week I mixed a batch of Inawera RY4 and filled up a tank today, yes I know it might be a bit early, but.... On the MPV the RY4 had little to no flavor and then I changed over to the vamo and it was like, Wow, this is pretty darn good RY4. So I would really like that good flavor to come out in the MPV. What ohm leel should I be shooting for to give the same or better experience on the MPV?

The kayfun with the RY4 is running 2.2 ohm micro coil with cotton wick

Thanks in advance.

 

[Steamer861]

You can use this site to get the rite combination
Watts - volts - amps - ohms conversion calculator

 

[BicStic]

So I built a new microcoil at 1.4 ohms and it seems much better. Thanks for the link.

 

[BeRight]

So I built a new microcoil at 1.4 ohms and it seems much better. Thanks for the link.

Yep - beat me to the punch - my sweet spot is 1.5 ohms at 8 watts MVP 2