Odysseus Illustrations

[Zoranth]

Here are the rest of the Illustrations. E2 Mode, E2 Mode with GGTS Base and Dripping mode for use in UFS. I did not make an illustration showing how to put the Dripping Mode in the UFS because it is the same as putting a standard atomizer in. But, if you need me to make one showing that, I will gladly do it.

The PDF versions can be found here: GG Product Illustrations

Odysseus Exploded (Dripping Mode For UFS)


Odysseus Exploded (E2 Mode)


Odysseus Exploded (E2 Mode - GGTS Base)

 

[fright88]

Looks great as always Zoranth and thanks again for all you do for the GG community.

 

[UncleDagger]

Ok. I've got a question. On the 510 illustrations. I'm having trouble understanding how the Mouthpiece cone nut is retained, it slides freely over the 510 atty that I have screwed into the Ody atomizer insert. If I try to screw the mouthpiece over it then it's just going to spin. If I screw the cone nut into the mouthpiece I'm going to eventually run out of threads to hold. Having trouble with that one piece. Everything else is very clear.

 

[fright88]

Set the I ring on the top edge of the cone nut (edge without the cut in it) place the nut groove down on your pointer finger and take the mouthpiece with your other hand and set it over the cone nut and o ring. Then tighten it into the mouthpiece. It doesn't have to be super tight it's sole purpose is to hold that I ring in place so if you tighten to much it can smash the o ring.

 

[UncleDagger]

Thanks! I think I have everything in the 510 mode set now. Just need to figure out how much juice I should put in it.