OFFICIAL: CyrstalClearVaping Information Thread..
- Thread starter cmdryker
- Start date
- th_trl_thread_readers 0
- Status
Only opened two but both of them have a very hard draw. Filled with a syringe and its pg/vg mix and pretty thin juice. Its like sucking on a McDonalds milkshake. Lol
Sent from my HTC Glacier using Tapatalk
Sent from my HTC Glacier using Tapatalk
I've never had a Resurrector with a hard draw when new, just when I've used one a while, and one of my juices starts clogging it up.
I get really stiff draws on resurrectors and DCCs when theyre around 2 weeks or so in use, but never right after opening them
I had one like that- being that I have used about 20+ of them so far.
I didn't think anything of it... but it's in the retired box, with many used others that need a cleaning...
I've been DIY juice testing, so a lot of them are still new-like, just need to be vaped and cleaned.
For the price, I love them! Most are lasting me a week+ Some are only a few days (depending on juice!)
With a few bad apples, I'm not worried... But if it's like every other one, I'd be upset too.
BTW- How many did you get?
I didn't think anything of it... but it's in the retired box, with many used others that need a cleaning...
I've been DIY juice testing, so a lot of them are still new-like, just need to be vaped and cleaned.
For the price, I love them! Most are lasting me a week+ Some are only a few days (depending on juice!)
With a few bad apples, I'm not worried... But if it's like every other one, I'd be upset too.
BTW- How many did you get?
Toweknee,
So I've noticed the same thing and for a while it kept me from even using them.....UNTIL I got a cool notion. OK folks, take a BOGE CARTO and take a SMOKETECH CARTO, hold them side by side, now flip them over and look VERY closely at the vertical or horizontal groove in the center post(depending on how your holding it ofcourse) and notice how much deeper the groove is in the BOGE. DEEP groove = airy draw, SHALLOW groove = heavy draw. Now the fix...(cool notion time) Take your dremel with a diamond tip bit that is the same width as the groove, and put a groove all the way across the whole thing,center post and outer thread wall all in 1 motion. It's up to you just how loose you want your draw by how deep you go but trust me it works GREAT. I've finally started liking smoketech cartos again now that you can't see the vein in my forehead every time I take a drag. Hope this helps you all out with this issue,IF it is one. ENJOY AND HAPPY VAPING !!!! ..........J
Check to see if the little side holes are present. I had a Boge once with no side holes and the draw was zero when connected to the battery. You should be able to put your finger over the bottom hole and still get a decent draw.
I haven't had any Resurrectors yet with a hard draw.
Is there an ETA for new stock of ST Resurrector cartos? I'm going to be ready to re-stock my supply in the next week or so. Also want to get some of the shorties. So just wondering.
Its does have the air holes in the side 3 of em actually. Still havent dremel the slot yet. Got to call my nephew to borrow his.
Great news resurrectors pre punched, ss, jr are air-borne,,in route as we type. be here bout 24 to 48 hours.
- Status
Similar threads
- Locked
- Locked
